CESSWI Site Inspection Procedures

Question 1

What is the primary goal of a site inspection?

Accepted Answer

Verify BMPs and compliance

Answer

The primary goal of a stormwater site inspection is to verify that Best Management Practices (BMPs) are correctly installed, maintained, and functioning as intended. Inspectors also ensure that the site is in compliance with all applicable stormwater permits and regulations. This proactive approach helps prevent pollution and protect water quality.

Question 2

When should site inspections typically occur?

Accepted Answer

Before, during, and after rain events

Answer

Site inspections for stormwater management should ideally occur before, during, and after rain events to provide a comprehensive assessment. Inspecting before a storm ensures BMPs are ready, during a storm allows observation of their performance under actual flow, and after a storm helps identify any damage or needed repairs. This timing ensures continuous effectiveness of erosion and sediment controls.

Question 3

What tool is commonly used during inspections?

Accepted Answer

Inspection checklist

Answer

An inspection checklist is a commonly used tool during stormwater inspections because it provides a structured and systematic approach. It ensures that all required elements, Best Management Practices (BMPs), and potential compliance issues are thoroughly reviewed and documented. This helps maintain consistency across inspections and ensures adherence to permit requirements.

Question 4

Why take photographs during inspection?

Accepted Answer

To document compliance or violations

Answer

Taking photographs during a stormwater inspection is crucial for documenting site conditions, Best Management Practices (BMPs), and any observed compliance or violations. These visual records provide objective evidence that can support inspection findings, illustrate the need for corrective actions, and serve as proof of resolution during follow-up assessments or audits.

Question 5

What should inspectors check for in BMPs?

Accepted Answer

Installation and maintenance status

Answer

Inspectors must check the installation and maintenance status of Best Management Practices (BMPs) to ensure their effectiveness in preventing stormwater pollution. Proper installation guarantees BMPs are built according to design specifications, while consistent maintenance ensures they remain functional and capable of controlling erosion and sediment over time. Both aspects are critical for compliance and environmental protection.

(CESSWI) Certified Erosion, Sediment, and Storm Water Inspector Practice Test

(CESSWI) Certified Erosion, Sediment, and Storm Water Inspector Practice Test

CESSWI Site Inspection Procedures