CTSP Regulatory Compliance (OSHA/Z133) Questions and Answers

Question 1

A tree care crew is performing incidental line clearance near a 13.2 kV distribution line. According to OSHA and ANSI Z133, what is the minimum approach distance (MAD) that an unqualified person must maintain from the energized conductors?

Accepted Answer

10 feet

Answer

Both OSHA (1910.333(c)(3)(i)) and ANSI Z133 specify that unqualified persons, including their tools and equipment, must maintain a minimum approach distance of at least 10 feet from overhead power lines rated 50 kV or below. This distance is a critical safety buffer to prevent accidental contact or electrical arc-over.

Question 2

According to OSHA's regulations for reporting work-related incidents, under which of the following circumstances must an employer report an event within 8 hours?

Accepted Answer

Any incident that results in a fatality of an employee.

Answer

OSHA's reporting requirements at 29 CFR 1904.39 are very specific. An employer must report the death of any employee from a work-related incident within 8 hours. In-patient hospitalizations, amputations, or the loss of an eye must be reported within 24 hours.

Question 3

An arborist is operating a chainsaw on the ground to buck logs. Which piece of personal protective equipment (PPE) is specifically required by the ANSI Z133 standard for this task?

Accepted Answer

Cut-resistant leg protection

Answer

ANSI Z133, Section 3.3.8, mandates that cut-resistant leg protection (such as chaps or saw pants) must be worn by workers while operating a chainsaw during ground operations. While other PPE is important and often required based on a hazard assessment, the cut-resistant leg protection is a specific requirement for this task.

Question 4

A CTSP is reviewing a company's safety procedures for line-clearance tree trimming operations. When is a second line-clearance tree trimmer required to be within unassisted voice communication of the first, according to OSHA 1910.269?

Accepted Answer

When roping is necessary to remove limbs from near energized conductors.

Answer

OSHA standard 1910.269(r)(1)(ii) specifies that a second line-clearance tree trimmer is required to be within normal voice range if, among other conditions, roping is necessary to remove branches or limbs from conductors or equipment. This ensures a spotter or rescuer is immediately available in a high-risk situation.

Question 5

OSHA does not have a comprehensive, single standard for all arboricultural operations. When citing a tree care company for a recognized hazard not covered by a specific OSHA standard, the agency often refers to the General Duty Clause in conjunction with which other document?

Accepted Answer

The ANSI Z133 Safety Standard.

Answer

Under the General Duty Clause (Section 5(a)(1) of the OSH Act), employers must provide a workplace free from recognized hazards. Because the tree care industry has widely recognized the ANSI Z133 standard, OSHA frequently uses it as the benchmark for identifying known hazards and establishing what a reasonable employer should have known or done to provide a safe workplace.

CTSP - Certified Treecare Safety Professional Practice Test

CTSP - Certified Treecare Safety Professional Practice Test

CTSP Regulatory Compliance (OSHA/Z133) Questions and Answers