CPSI Specific Equipment Standards for Swings and Slides 2

Question 1

According to ASTM F1487, what is the minimum use zone clearance in front of and behind a belt swing for children ages 5-12?

Accepted Answer

Twice the height of the pivot point

Answer

ASTM F1487 requires the use zone in front of and behind a swing to extend a minimum distance equal to twice the height of the pivot point from directly below it.

Question 2

What type of swing seat is specifically prohibited on tot-lot equipment intended for children ages 2-5 under ASTM F1487?

Accepted Answer

Animal-figure swings

Answer

Animal-figure swings (also called 'fun' or 'novelty' swings) with rigid animal shapes are prohibited on equipment intended for children ages 2-5 because they present significant impact hazard to other children.

Question 3

ASTM F1487 specifies that the angle of a slide chute relative to the horizontal should not exceed what maximum value for traditional straight slides?

Accepted Answer

35 degrees

Answer

ASTM F1487 specifies that the angle of a traditional slide chute should not exceed 35 degrees from the horizontal to prevent children from gaining excessive speed during descent.

Question 4

What is the required minimum overhead clearance for a slide exit?

Accepted Answer

16 inches (400 mm)

Answer

ASTM F1487 requires a minimum of 16 inches (400 mm) of clearance between the bottom of the slide exit and the protective surfacing to allow for adequate landing space.

Question 5

Which of the following is a key safety requirement for swing hangers under ASTM F1487?

Accepted Answer

Swing hangers must allow independent movement of adjacent swings to prevent entanglement

Answer

ASTM F1487 requires that swing hangers allow each swing to move independently of adjacent swings, preventing entanglement and chain-wrapping hazards.

CPSI - Certified Playground Safety Inspector Practice Test

CPSI - Certified Playground Safety Inspector Practice Test

CPSI Specific Equipment Standards for Swings and Slides 2