CIT - Certified Irrigation Technician System Installation and Layout Questions and Answers

Question 1

A technician is installing a PVC mainline in a trench. To ensure a strong, watertight seal when joining a pipe and fitting using solvent cement, what is the critical first step after cutting and deburring the pipe?

Accepted Answer

Apply a full, even coat of primer to the outside of the pipe end and the inside of the fitting socket.

Answer

Applying primer is a crucial step that softens the surfaces of the PVC pipe and fitting, allowing the solvent cement to create a chemical weld. Skipping this step or applying it incorrectly can result in a weak bond and potential leaks.

Question 2

When laying out sprinkler heads for a turf zone, what is the industry best practice for ensuring uniform water distribution and avoiding dry spots?

Accepted Answer

Arranging sprinklers to achieve head-to-head coverage.

Answer

Head-to-head coverage, where the spray from one sprinkler head reaches the adjacent sprinkler head, is the industry standard for achieving the most uniform water distribution across an irrigation zone. This overlap compensates for variations in spray patterns and wind, preventing dry spots between heads.

Question 3

A residential irrigation system plan specifies a Pressure Vacuum Breaker (PVB) for backflow prevention. Which of the following is a mandatory installation requirement for this device?

Accepted Answer

It must be installed at least 12 inches above the highest outlet in the irrigation system.

Answer

Pressure Vacuum Breakers (PVBs) are designed to prevent back-siphonage and must be installed at a minimum elevation of 12 inches above the highest sprinkler head or outlet they serve. This elevation is critical for the air inlet valve to function correctly and protect the potable water supply.

Question 4

During a commercial installation, what is the generally accepted minimum trench depth for PVC lateral lines to protect them from routine landscape maintenance activities and light traffic?

Accepted Answer

12 inches

Answer

For commercial installations, a minimum depth of 12 inches to the top of the lateral pipe is a common industry standard. This depth provides adequate protection from aeration equipment, shovels, and other potential surface damage.

Question 5

After solvent welding several PVC joints on a hot, dry day (approx. 90°F), a technician is anxious to test the mainline for leaks. According to most solvent cement manufacturers' guidelines for pipes 1¼" or smaller under 160 psi, what is the minimum cure time before the system can be safely pressurized?

Accepted Answer

15 minutes

Answer

Cure time is the period required for a solvent-welded joint to gain full strength. While set time (when the joint can be handled) is very short, pressurizing the system too early can cause joint failure. For smaller pipes in warm conditions, a minimum cure time of 15 minutes is often specified for pressures up to 160 psi, though longer times are needed for higher pressures, larger pipes, or colder temperatures.

CIT - Certified Irrigation Technician Practice Test

CIT - Certified Irrigation Technician Practice Test

CIT - Certified Irrigation Technician System Installation and Layout Questions and Answers