CCT CCT Quality Control & Testing Procedures

Question 1

What is the primary purpose of a functional acceptance test on a Casper system before deployment?

Accepted Answer

To verify all components meet performance specifications

Answer

Functional acceptance testing confirms that all system components operate within specified performance parameters before the unit is handed over to the customer.

Question 2

Which document provides the benchmark values used when performing quality inspections on a Casper unit?

Accepted Answer

Manufacturer's technical specification sheet

Answer

The manufacturer's technical specification sheet lists the exact tolerances and benchmark values that inspectors compare against measured results during quality checks.

Question 3

During a post-installation quality audit, a technician discovers sensor readings are consistently 5% above the calibrated baseline. What is the correct first step?

Accepted Answer

Document the deviation and recalibrate per the service manual

Answer

Any out-of-tolerance reading must be documented and then corrected through the recalibration procedure outlined in the service manual before the system is approved.

Question 4

What does a red-tag hold on a Casper component indicate in a quality-control workflow?

Accepted Answer

The component is quarantined due to a defect or non-conformance

Answer

A red-tag (quarantine tag) signals that the component has failed inspection or is suspected defective and must not be used until disposition is determined.

Question 5

Which inspection method involves examining a Casper system's connections and mounts visually without energizing the system?

Accepted Answer

Pre-energization visual inspection

Answer

Pre-energization visual inspection checks physical integrity—connections, mounts, and wiring—before power is applied to prevent damage from assembly errors.

(CCT) Certified Casper Technician Practice Test

(CCT) Certified Casper Technician Practice Test

CCT CCT Quality Control & Testing Procedures