BEE Bachelor of Electrical Engineering Control System Principles Questions and Answers

Question 1

A control system has a characteristic equation given by s³ + 6s² + 11s + 6 = 0. According to the Routh-Hurwitz stability criterion, what can be concluded about the stability of this system?

Accepted Answer

The system is stable.

Answer

To determine stability using the Routh-Hurwitz criterion, we first check the necessary condition: all coefficients must be present and have the same sign. In this case (1, 6, 11, 6), all are positive. Next, we form the Routh array. The first column elements are 1, 6, 10, and 6. Since there are no sign changes in the first column of the Routh array, the system is stable.

Question 2

An engineer is designing a closed-loop control system for a DC motor's position. After implementing a proportional (P) controller, they observe a persistent difference between the desired final position and the actual final position. Which type of control action should be added to eliminate this steady-state error?

Accepted Answer

Integral (I) control

Answer

The integral (I) component of a PID controller sums the error over time. This accumulated sum causes the controller output to increase until the steady-state error is driven to zero. Proportional control alone often results in a non-zero steady-state error, and derivative control primarily affects the transient response (like overshoot) rather than the final error.

Question 3

For a unity feedback control system, what is the steady-state error for a Type 1 system subjected to a unit step input?

Accepted Answer

Zero

Answer

The 'type' of a system is determined by the number of pure integrators (poles at the origin) in its open-loop transfer function. A Type 1 system has one integrator. The position error constant (Kp) for a Type 1 system is infinite. The steady-state error for a step input is calculated as 1 / (1 + Kp). Since Kp is infinite, the steady-state error is 1 / (1 + ∞), which equals zero.

Question 4

Which of the following correctly defines the phase margin in the context of a Bode plot analysis?

Accepted Answer

The difference between the system's phase angle and -180 degrees at the gain crossover frequency.

Answer

The phase margin is a measure of relative stability. It is found at the gain crossover frequency (where the magnitude plot is 0 dB). The phase margin is the amount of additional phase lag required to make the system unstable, calculated as the difference between the system's phase at that frequency and -180 degrees.

Question 5

According to the fundamental rules for constructing a root locus plot for a system with an open-loop transfer function G(s)H(s), where do the branches of the root locus begin (for K=0)?

Accepted Answer

At the open-loop poles of G(s)H(s)

Answer

The root locus plot shows the paths of the closed-loop poles as a system parameter (typically gain K) varies from 0 to infinity. The branches of the root locus always start (when K=0) at the poles of the open-loop transfer function G(s)H(s) and terminate (as K approaches infinity) at the zeros of the open-loop transfer function or at infinity.

BEE - Bachelor of Electrical Engineering Practice Test

BEE - Bachelor of Electrical Engineering Practice Test

BEE Bachelor of Electrical Engineering Control System Principles Questions and Answers