OFTEC Combustion Efficiency Testing 4

Question 1

What is the significance of the dew point temperature in condensing oil boilers?

Accepted Answer

It is the temperature at which water vapour in flue gases condenses, recovering latent heat

Answer

In condensing boilers, when flue gas temperature drops below the dew point (approximately 47°C for kerosene), water vapour condenses and releases latent heat. This recovered heat boosts efficiency above the theoretical 100% (gross) figure.

Question 2

What is a CO/CO2 ratio and what does it indicate?

Accepted Answer

The proportion of CO to CO2 — a high ratio indicates dangerous incomplete combustion

Answer

The CO/CO2 ratio compares carbon monoxide (incomplete combustion) to carbon dioxide (complete combustion). A ratio above 0.004 indicates poor combustion that could be dangerous. It is a key safety indicator during testing.

Question 3

What reading on a flue gas analyser would indicate a potentially dangerous appliance requiring immediate action?

Accepted Answer

CO reading above 200 ppm in the undiluted flue gas

Answer

CO readings above 200 ppm indicate severely incomplete combustion and an immediate danger. The appliance should be turned off, the customer warned not to use it, and a 'Do Not Use' label applied until repairs are completed.

Question 4

Why must combustion readings be taken with all boiler covers and panels in place?

Accepted Answer

Removing covers changes the air supply and gives false readings that don't represent normal operation

Answer

Removing boiler covers changes the air flow to the burner, giving readings that do not represent how the boiler actually operates when the covers are fitted. Tests must replicate real operating conditions for accurate results.

Question 5

What does a CO2 reading below 8% on a kerosene pressure jet burner typically indicate?

Accepted Answer

Excessive air is entering the combustion zone

Answer

A CO2 reading below 8% for kerosene indicates significantly too much excess air. This wastes heat up the flue, reduces efficiency, and may cause flame instability. The air band settings need adjusting to increase CO2 towards 10-12%.

OFTEC Practice Test

OFTEC Practice Test

OFTEC Combustion Efficiency Testing 4