OFTEC Combustion Efficiency Testing 2

Question 1

What is the minimum acceptable combustion efficiency for a new oil-fired boiler at commissioning?

Accepted Answer

85%

Answer

New oil-fired boilers should achieve a minimum combustion efficiency of 85% at commissioning. Modern condensing oil boilers typically achieve 90-95%. Lower readings indicate a problem requiring investigation.

Question 2

What does excess air in combustion mean for boiler efficiency?

Accepted Answer

It reduces efficiency as heat is wasted heating unused air that goes up the flue

Answer

Excess air beyond what is needed for combustion absorbs heat as it passes through the boiler and carries that heat up the flue. While some excess air is necessary for safe combustion, too much wastes energy.

Question 3

What is the correct position to take a flue gas sample from an oil-fired appliance?

Accepted Answer

In the flue pipe, at the test point closest to the appliance outlet

Answer

The flue gas sample should be taken from the test point in the flue pipe as close to the appliance flue outlet as practical. This gives the most accurate reading before the gases are diluted by any air ingress further up the flue.

Question 4

How long should an oil burner run before taking combustion readings?

Accepted Answer

At least 10-15 minutes to reach stable operating conditions

Answer

The burner should run for at least 10-15 minutes to reach stable operating conditions before taking readings. Cold-start readings are unreliable as the combustion chamber temperature affects the combustion process.

Question 5

What does a high oxygen (O2) reading in the flue gas indicate?

Accepted Answer

Too much excess air is entering the combustion process

Answer

High O2 readings (above 6-7% for kerosene) indicate excessive air entering the combustion zone. This lowers CO2, reduces efficiency, and may cause flame instability. The air band or damper needs adjusting.

OFTEC Practice Test

OFTEC Practice Test

OFTEC Combustion Efficiency Testing 2