NSC Maintenance & Inspection Procedures 2

Question 1

When should the hydraulic fluid level on a forklift be checked?

Accepted Answer

Before each shift as part of the pre-shift inspection

Answer

Hydraulic fluid level must be checked before each shift during the pre-shift inspection to ensure safe lifting operation.

Question 2

A forklift operator notices the mast chains are dry and show visible rust. What is the correct action?

Accepted Answer

Apply chain lubricant immediately and tag the unit for maintenance

Answer

Rusty, dry mast chains are a safety hazard and must be lubricated and the unit flagged for maintenance before continued use.

Question 3

Which component should be inspected for cracks, bends, or excessive wear during a forklift pre-shift check?

Accepted Answer

The forks

Answer

Forks must be inspected for cracks, bends, and wear because damaged forks can fail under load and cause serious injuries.

Question 4

What does a red tag placed on a forklift indicate?

Accepted Answer

The forklift is out of service and must not be operated

Answer

A red tag is used to indicate that equipment is out of service and must not be operated until repaired and cleared.

Question 5

During inspection, the operator finds that the forklift's overhead guard has a cracked weld. What should happen next?

Accepted Answer

Remove the forklift from service immediately and report the damage

Answer

A cracked overhead guard compromises operator protection from falling objects and requires immediate removal from service.

NSC Practice Test