Quality Control & Inspection Flashcards
7 cards from real NSC practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 7 Quality Control & Inspection flashcards as text
When inspecting an electric forklift, which battery condition is considered a safety hazard?
Answer: Battery casing that is cracked or leaking
A cracked or leaking battery casing can release corrosive electrolyte and hydrogen gas, creating both chemical and fire hazards.
How should an operator check the steering mechanism during a pre-shift walkaround inspection?
Answer: Inspect for play in the steering wheel and check for fluid leaks at steering components
Checking for excessive play in the steering wheel and inspecting for fluid leaks at steering components are both part of a thorough pre-shift steering inspection.
An operator notices that one of the forklift's warning lights on the instrument panel is illuminated. What should they do?
Answer: Consult the operator's manual or report to a supervisor before operating
Illuminated warning lights signal system faults that must be investigated using the operator's manual or reported to a supervisor before the forklift is used.
What does inspecting the forklift's mast chains for proper lubrication prevent?
Answer: Premature chain wear and potential chain failure
Proper lubrication of mast chains prevents metal-to-metal contact that causes accelerated wear, which can lead to unexpected chain failure and dropped loads.
During a walk-around inspection, the operator finds the fuel cap on a propane forklift is missing. What should occur?
Answer: Remove the unit from service — operating without a fuel cap is a fire and explosion hazard
A missing propane fuel cap creates a risk of fuel release and ignition; the forklift must be removed from service until the cap is replaced.
Which of the following is the correct action when the operator's compartment restraint (seatbelt or operator restraint system) is found to be broken?
Answer: Remove the forklift from service until the restraint is repaired
Operator restraint systems are required safety equipment per OSHA and ANSI standards; a broken restraint requires the forklift to be taken out of service.
What is the purpose of inspecting the forklift's finger guards on the carriage during quality control checks?
Answer: They prevent operator fingers from entering the chain/carriage mechanism
Finger guards on the carriage are safety devices that prevent the operator's fingers from being caught in the chain and carriage assembly during mast operation.