New Zealand Motorbike Driving Test New Zealand Motorbike Driving Rider Safety and PPE 3 — Questions and Answers
Question 1: Why should motorcycle boots extend above the ankle?
- To meet fashion standards
- To protect the ankle and foot from injury during a crash or tip-over (Correct answer)
- To improve foot grip on footpegs
- To prevent the foot from slipping off the brake
Correct answer: To protect the ankle and foot from injury during a crash or tip-over
Ankle-high motorcycle boots support and protect the ankle joint, which is highly vulnerable during crashes and tip-overs.
Question 2: What does CE certification on motorcycle protective gear indicate?
- The gear is manufactured in China or Europe
- The gear meets European safety standards for impact protection (Correct answer)
- The gear is waterproof
- The gear is approved by the NZ Transport Agency
Correct answer: The gear meets European safety standards for impact protection
CE certification means the protective armour in the gear meets established European safety standards for impact absorption.
Question 3: A rider notices their helmet's chin strap is frayed and worn. What should they do?
- Continue using it until the strap breaks
- Replace the helmet immediately (Correct answer)
- Tape the strap temporarily
- Remove the strap as it is optional
Correct answer: Replace the helmet immediately
A damaged chin strap can fail in a crash, allowing the helmet to come off; the helmet should be replaced.
Question 4: Which of the following best describes the 'ATGATT' principle followed by safe riders?
- All Traffic Goes At The Same Time
- All The Gear, All The Time (Correct answer)
- Awareness Training Guarantees Accident-free Travel Today
- Armour, Throttle, Gear, Acceleration, Technique, Traffic
Correct answer: All The Gear, All The Time
'All The Gear, All The Time' means wearing full protective equipment on every ride, regardless of distance or conditions.
Question 5: What is the recommended way to check if a motorcycle helmet fits correctly?
- Shake your head vigorously — the helmet should move freely
- The helmet should feel snug with no pressure points and not move independently (Correct answer)
- There should be a two-finger gap between the helmet and the head
- The chin strap should be loose enough to insert a fist
Correct answer: The helmet should feel snug with no pressure points and not move independently
A correctly fitted helmet sits snugly, does not move independently from the head, and has no uncomfortable pressure points.
Question 6: In wet conditions, which additional PPE consideration is most important for a motorcyclist?
- Wearing a heavier jacket for warmth only
- Adding waterproof over-layers to prevent cold and maintain dexterity (Correct answer)
- Removing gloves to improve grip on controls
- Using a lighter helmet to reduce neck strain
Correct answer: Adding waterproof over-layers to prevent cold and maintain dexterity
Waterproof over-layers prevent hypothermia and keep the rider dry, maintaining concentration and control in wet weather.
Question 7: What should a rider do if their visor fogs up while riding in cold or wet conditions?
- Remove the helmet and continue riding
- Slightly open the visor or use an anti-fog insert/pin-lock system (Correct answer)
- Accelerate to clear the fog with wind
- Pull down sunglasses over the visor
Correct answer: Slightly open the visor or use an anti-fog insert/pin-lock system
Cracking the visor open or using an anti-fog pin-lock insert allows airflow to prevent fogging while maintaining eye protection.
New Zealand Motorbike Driving Test New Zealand Motorbike Driving Rider Safety and PPE 3
Why should motorcycle boots extend above the ankle?