NCCT - National Certified Phlebotomy Technician Collection Complications and Corrections Questions and Answers 1

Question 1

A phlebotomist applies a tourniquet and is momentarily distracted, leaving it on the patient's arm for nearly three minutes before performing the venipuncture. This delay is most likely to cause what type of preanalytical error?

Accepted Answer

Hemoconcentration

Answer

Leaving a tourniquet on for longer than one minute causes venous stasis, where plasma is forced out of the vein into the surrounding tissue. This results in an increased concentration of non-filterable analytes like proteins, enzymes, and cells in the blood specimen, a condition known as hemoconcentration.

Question 2

Which of the following procedural errors is a common cause of hemolysis, the rupture of red blood cells, in a blood specimen?

Accepted Answer

Vigorously shaking the collection tube after the draw

Answer

Vigorously shaking a tube creates mechanical trauma that can rupture red blood cells, leading to hemolysis. Tubes with additives should be gently inverted the specified number of times to ensure proper mixing without damaging the cells.

Question 3

During a venipuncture on a patient with small veins, the phlebotomist observes that the blood flow into the evacuated tube stops after only a small amount has been collected and the vein appears to flatten. What is the most likely cause of this complication?

Accepted Answer

The vacuum of the evacuated tube is too strong for the vein

Answer

A collapsed vein occurs when the pressure exerted by the evacuated tube's vacuum is greater than the pressure of the blood flowing through the vein, causing the vein walls to draw together and stop the flow. This is more common in patients with small or fragile veins.

Question 4

A phlebotomist performing a venipuncture in the antecubital area notices the blood in the collection tube is bright red and filling rapidly with a pulsating flow. What is the phlebotomist's most appropriate immediate action?

Accepted Answer

End the draw, remove the needle, and apply firm pressure for at least 5-10 minutes

Answer

Bright red, pulsating blood is a clear sign of an inadvertent arterial puncture. Because arterial pressure is much higher than venous pressure, the immediate priority is to stop the procedure and apply significant, prolonged pressure to the site to prevent a large hematoma and control bleeding.

Question 5

After applying a tourniquet to a patient's arm, the phlebotomist observes small, non-raised red spots appearing on the skin below the tourniquet. What does this clinical sign indicate?

Accepted Answer

The formation of petechiae, suggesting capillary fragility

Answer

The appearance of small red spots, or petechiae, after tourniquet application indicates minor hemorrhage from fragile capillaries. This can be a sign of a low platelet count or other coagulation issues, and the phlebotomist should be prepared to apply extra pressure to the site after the draw to ensure bleeding stops.

NCCT - National Certified Phlebotomy Technician Exam Practice Test

NCCT - National Certified Phlebotomy Technician Exam Practice Test

NCCT - National Certified Phlebotomy Technician Collection Complications and Corrections Questions and Answers 1