NCCER Crane Crane Regulations & Standards (OSHA 1926 Subpart CC / ASME B30.5)

Question 1

Which OSHA regulation covers cranes and derricks used in construction?

Accepted Answer

29 CFR 1926 Subpart CC

Answer

29 CFR 1926 Subpart CC (1926.1400–1926.1442) is OSHA's construction standard for cranes and derricks. Subpart N of 1910 covers general industry, Subpart M covers fall protection, and 1904 covers injury recordkeeping.

Question 2

Which ASME consensus standard applies specifically to mobile and locomotive cranes?

Accepted Answer

ASME B30.5

Answer

ASME B30.5 covers mobile and locomotive cranes. B30.9 covers slings, B30.3 covers tower cranes, and B30.26 covers rigging hardware.

Question 3

Under OSHA 1926.1427, what is the maximum period an operator certification is valid before recertification?

Accepted Answer

5 years

Answer

OSHA 1926.1427 limits an operator certification to a maximum of 5 years. After that, the operator must recertify.

Question 4

Under Subpart CC, who must perform the inspection of a crane at the start of each shift?

Accepted Answer

A competent person

Answer

OSHA 1926.1412 requires a competent person to perform a visual shift inspection before or during each shift. Annual or comprehensive inspections require a qualified person.

Question 5

If the voltage of a nearby power line is unknown, what minimum clearance does OSHA require between the line and any part of the crane, load or load line?

Accepted Answer

20 feet

Answer

Under 1926.1408, when the voltage is unknown or the employer uses Option 1, the minimum clearance is 20 feet. The utility must confirm the voltage before Table A distances can be used.

(NCCER Crane) National Center for Construction Education and Research Crane Certification Practice Test

(NCCER Crane) National Center for Construction Education and Research Crane Certification Practice Test

NCCER Crane Crane Regulations & Standards (OSHA 1926 Subpart CC / ASME B30.5)