NABCEP Electrical Component Inspection 5

Question 1

An inspector reviews commissioning records and notices that the measured Isc of a PV string is 18% higher than the nameplate Isc value. What is the most likely explanation?

Accepted Answer

Irradiance at the time of measurement exceeded 1000 W/m² STC conditions

Answer

Isc increases proportionally with irradiance; measurements taken under conditions exceeding STC irradiance (e.g., on high-altitude clear days with reflected light) can produce Isc values higher than nameplate.

Question 2

During an inspection, a technician finds that the AC output conductors from the inverter to the AC disconnect are 8 AWG THWN-2 copper rated at 50A, and the AC disconnect has a 60A fuse. The inverter's output circuit breaker is rated at 30A. Is there an issue?

Accepted Answer

Yes, the 60A fuse exceeds the conductor ampacity and must be replaced with a 50A fuse

Answer

The overcurrent device protecting a conductor must not exceed the conductor's ampacity; 8 AWG THWN-2 copper is rated for 50A, so the 60A fuse in the AC disconnect violates this requirement.

Question 3

During inspection of a rooftop installation, you find that PV conductors run across a flat EPDM roof membrane without any protection or support. What is the primary concern?

Accepted Answer

Abrasion damage to conductor insulation from roof traffic and thermal movement

Answer

Conductors on roof membranes are subject to insulation abrasion from foot traffic, thermal expansion, and debris, which can cause insulation damage and eventual ground faults.

Question 4

An inspector finds that a PV system uses a transformer-less inverter and the modules are frameless thin-film. Which grounding approach is required?

Accepted Answer

Functional ground connection per manufacturer requirements, not traditional EGC bonding

Answer

Certain thin-film module technologies require a specific functional grounding polarity per manufacturer instructions to prevent potential-induced degradation (PID), overriding standard EGC approaches.

Question 5

During a system inspection, you find that a microinverter AC branch circuit has 15 microinverters, each with a maximum output of 230VA. The branch circuit breaker is rated at 20A at 240V single-phase. Does this comply with NEC 705.12?

Accepted Answer

No, the output current of 14.4A exceeds 80% of the 20A breaker (16A) and must be on a 20A breaker after applying the 125% continuous load rule

Answer

Inverter output circuits are considered continuous loads, so the calculated load (14.4A) must not exceed 80% of the overcurrent device rating (16A for a 20A breaker); 14.4A is within the 16A limit, making this installation compliant.

(NABCEP) Certified North American Board of Certified Energy Practitioners Specialist Practice Test

(NABCEP) Certified North American Board of Certified Energy Practitioners Specialist Practice Test

NABCEP Electrical Component Inspection 5