Practice Test GeeksMSF - Motorcycle Safety Foundation Practice Test
← All MSF Flashcard Decks

Pre-Ride Inspection (T-CLOCS) Flashcards

7 cards from real MSF practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Pre-Ride Inspection (T-CLOCS) flashcards as text

  1. During the 'O' check in T-CLOCS, you notice the brake fluid reservoir is below the minimum line. This means:

    Answer: The brakes may be worn or there is a leak — investigate before riding

    Low brake fluid indicates worn brake pads (which consume fluid volume) or a leak; either condition must be diagnosed and corrected before riding.

  2. When checking suspension during the Chassis (second C) portion of T-CLOCS, you should:

    Answer: Compress forks and bounce rear suspension to check for smooth, controlled travel

    Pushing down on forks and the rear of the seat checks that suspension compresses and rebounds smoothly without binding, bottoming out, or oil leaks.

  3. In T-CLOCS, checking that mirrors are properly adjusted falls under which category?

    Answer: Lights and Electrics

    Mirrors are part of the Lights and Electrics category in T-CLOCS, ensuring the rider has adequate rear visibility before departing.

  4. What is the correct way to check for wheel bearing play during a T-CLOCS inspection?

    Answer: Grasp the wheel at top and bottom and try to wiggle it side to side

    Grasping the top and bottom of the stationary wheel and rocking it reveals lateral play in wheel bearings that could indicate bearing failure.

  5. Why is it important to check coolant level on liquid-cooled motorcycles as part of the 'O' step?

    Answer: Low coolant can cause engine overheating and serious damage

    Insufficient coolant in a liquid-cooled engine can rapidly lead to overheating, causing engine seizure or severe internal damage.

  6. During a Controls check, you find the brake pedal has excessive freeplay before engaging. What should you do?

    Answer: Adjust or repair the brake before riding

    Excessive brake pedal freeplay indicates the need for adjustment or signals a hydraulic/mechanical issue that must be corrected before the motorcycle is ridden.

  7. Which of the following is an example of a 'Chassis' item inspected in T-CLOCS?

    Answer: Drive belt condition and tension

    Drive belt (or chain/shaft) condition and tension is a Chassis item, as it transfers engine power to the rear wheel and must be within spec.