Movement Belay Certification Informational Text 4

Question 1

A Movement certification packet lists the 'buddy check.' What is the correct order of a partner check before climbing?

Accepted Answer

Check harness, knot, belay device setup, and communication — in that order

Answer

The standardized buddy check follows harness → knot → belay device → communication to ensure nothing is missed.

Question 2

An informational text explains that a figure-eight follow-through knot is retied through the harness tie-in points. Which statement about tie-in points is correct?

Accepted Answer

The knot passes through both the belay loop and the waistbelt tie-in point, not the belay loop alone

Answer

The figure-eight must pass through both the waist belt and leg loop tie-in points — never only the belay loop.

Question 3

A safety information sheet states a proper figure-eight follow-through must have a 'tail.' Why?

Accepted Answer

The tail confirms the knot was tied completely through, leaving enough rope to prevent the knot from untying

Answer

A tail of at least 4–6 inches shows the knot was fully threaded and provides material for the knot to remain secure under load.

Question 4

According to a belay guide, what is the danger of using a belay device that is too large for the rope diameter in use?

Accepted Answer

The rope slides through with less friction, making it harder to hold a fall

Answer

Using an oversized device for a thin rope reduces braking friction, potentially allowing the rope to slide during a fall.

Question 5

A gym poster displays the command sequence for starting a climb. What does the climber say FIRST?

Accepted Answer

'On belay?'

Answer

The climber asks 'On belay?' to confirm the belayer is set up and ready before starting to climb.

Movement Belay Certification Practice Test

Movement Belay Certification Practice Test

Movement Belay Certification Informational Text 4