Vehicle Inspection Standards Flashcards
7 cards from real Motor Vehicle Division practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 7 Vehicle Inspection Standards flashcards as text
A vehicle's seat belt pretensioner has been deployed after a minor collision. The belt still latches. Does it pass inspection?
Answer: No, a deployed pretensioner must be replaced before passing
A deployed pretensioner is a single-use device and no longer provides the designed restraint force; it must be replaced even if the belt appears functional.
When checking headlight aim during inspection, which problem would cause a failure?
Answer: Headlights aimed so high they would blind oncoming drivers
Headlights aimed too high create a glare hazard for oncoming traffic and are a safety violation causing inspection failure.
Which of the following window tint situations would cause a vehicle to fail a safety inspection in most US states?
Answer: Tint on the front side windows below the legal limit for that state
Front side windows must meet the state's minimum visible light transmission (VLT) requirement; tint darker than the legal limit causes a failure.
An inspector finds that a vehicle's rear reflectors are faded and no longer reflective. What is the correct outcome?
Answer: Fail because reflectors are required safety equipment
Rear reflectors are required safety equipment that allows other drivers to see the vehicle in low-light conditions without headlights; non-functional reflectors cause a failure.
During inspection, a technician performs a bounce test on the front of a vehicle and the car continues to oscillate more than twice. What does this indicate?
Answer: Worn or failed shock absorbers or struts
A vehicle that oscillates more than 1-2 times after a bounce test indicates worn shocks or struts that can no longer dampen suspension movement effectively.
Which condition regarding a vehicle's battery would typically cause a safety inspection failure?
Answer: Loose or severely corroded battery terminals that affect electrical system operation
Severely corroded or loose battery terminals that interfere with the electrical system's operation are a safety concern that causes an inspection failure.
A vehicle has an aftermarket LED conversion kit installed in housings designed for halogen bulbs. Why might this fail inspection?
Answer: The housing optics are designed for halogen and may create dangerous glare with LEDs
Projector or reflector housings designed for halogen bulbs do not properly focus LED light output, often creating uncontrolled glare that can blind other drivers.