MHIC Construction Methods and Materials 6

Question 1

During a bathroom renovation, a homeowner wants to tile directly over an existing drywall surface in a wet zone (shower walls). What should the contractor do?

Accepted Answer

Remove the drywall and install cement board or a tile backer designed for wet areas

Answer

Standard drywall (gypsum board) deteriorates when exposed to repeated moisture even with a waterproofing membrane on top. The correct approach is to remove it and install a proper tile backer such as cement board, fiber-cement board, or an equivalent wet-area substrate. These materials are dimensionally stable and will not degrade behind tile in shower applications.

Question 2

A contractor is installing a load-bearing wall using light-gauge steel framing in a residential project. What is the minimum yield strength typically required for structural steel framing members used in load-bearing applications?

Accepted Answer

33 ksi (kilopounds per square inch)

Answer

Steel framing members used in load-bearing applications typically require a minimum yield strength of 33 ksi (33,000 psi), as specified by AISI standards. This grade (commonly ASTM A653 Grade 33) provides the structural integrity needed for load-bearing walls while remaining workable for field fabrication.

Question 3

A contractor is pouring a concrete slab on grade in cold weather (ambient temperature 35°F). Which of the following practices is MOST important to prevent freeze damage to the fresh concrete?

Accepted Answer

Use accelerating admixtures and maintain the concrete temperature above 50°F during curing

Answer

In cold weather concreting, accelerating admixtures (such as calcium chloride in non-reinforced slabs) help speed up strength gain, and maintaining concrete temperature above 50°F (per ACI 306) ensures proper hydration and prevents freezing before the concrete achieves adequate strength. Adding water or increasing the water-to-cement ratio actually weakens the mix and should never be done.

Question 4

When framing a door rough opening in a wood-framed exterior wall, what is the purpose of the jack stud (also called a trimmer stud)?

Accepted Answer

To bear the load of the header and transfer it to the bottom plate

Answer

The jack stud (trimmer stud) runs vertically alongside the king stud and supports the ends of the header directly. It bears the header's load — which includes any loads transferred from above — and transfers that load down through the bottom plate to the foundation. The king stud provides lateral stability, but the jack stud is the direct vertical support for the header.

Question 5

A contractor installs a new asphalt shingle roof and notices the existing roof deck has areas of oriented strand board (OSB) with surface delamination and soft spots. What is the correct corrective action before shingling?

Accepted Answer

Cut out and replace all deteriorated or structurally compromised OSB panels

Answer

Delamination and soft spots in OSB indicate moisture damage and structural degradation. Applying roofing cement or felt paper over compromised decking does not restore structural integrity and can trap moisture, worsening the problem. The correct action is to cut out and replace all damaged sections with new sheathing to provide a solid, uniform nailing surface and proper load distribution for the shingles.

(MHIC) Maryland Home Improvement Contractor Practice Test

(MHIC) Maryland Home Improvement Contractor Practice Test

MHIC Construction Methods and Materials 6