MHIC Construction Methods and Materials 1

Question 1

In platform frame construction, what is the primary structural purpose of the double top plate used at the top of exterior and interior bearing walls?

Accepted Answer

To tie walls together at intersections and distribute roof/floor loads across multiple studs

Answer

The double top plate ties wall sections together at corners and intersections, lapping joints to create continuity. It also helps distribute concentrated loads from joists, rafters, or beams above across multiple studs below. It is not a weather barrier, its drywall nailing role is incidental, and it does not significantly improve fire resistance.

Question 2

Which masonry unit type is correctly matched with its primary composition?

Accepted Answer

Adobe — sun-dried earthen material with straw or other stabilizers

Answer

Adobe is traditionally made from earth (clay-rich soil), water, and organic material like straw, then sun-dried rather than kiln-fired. CMUs are made from Portland cement, aggregate, and water — not fired clay. Bricks are made from fired clay or shale, not cement. Glass block is made from soda-lime glass, not borosilicate.

Question 3

A homeowner wants to add a load-bearing wall in their basement. Which type of foundation footing is most commonly required beneath a new interior load-bearing wall in residential construction?

Accepted Answer

Continuous strip footing

Answer

A continuous strip footing (also called a continuous wall footing) runs the full length beneath a load-bearing wall, distributing the wall's load evenly along the soil. Isolated spread footings support individual columns or posts, not continuous walls. Pile and raft foundations are used in specialized conditions not typical for residential interior walls.

Question 4

When framing a residential floor system, which engineered lumber product is most commonly used today as a substitute for solid-sawn dimensional lumber joists because it offers greater dimensional stability and longer spans?

Accepted Answer

I-joists (wood I-beams)

Answer

I-joists (wood I-beams) are the most common engineered product used as floor joists in modern residential construction. Their flanged profile resists bending and allows longer spans with less material. LVL is used primarily for beams and headers, glulam for large beams, and OSB is a sheathing panel, not a joist.

Question 5

A contractor is selecting concrete for a basement floor slab that will be exposed to freeze-thaw cycles and deicing salts. Which concrete specification is most critical for durability in this application?

Accepted Answer

Air-entrained concrete with low water-cement ratio

Answer

Air-entrained concrete with a low water-cement ratio is essential for freeze-thaw durability. Air entrainment creates microscopic bubbles that relieve pressure as water expands when freezing. A low water-cement ratio increases strength and reduces permeability. High slump and high water-cement ratios both weaken concrete and reduce durability.

(MHIC) Maryland Home Improvement Contractor Practice Test

(MHIC) Maryland Home Improvement Contractor Practice Test

MHIC Construction Methods and Materials 1