Mechanical Aptitude Hydraulics and Pneumatics 1 Flashcards
6 cards from real MECHANICAL APTITUDE practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 6 Mechanical Aptitude Hydraulics and Pneumatics 1 flashcards as text
A hydraulic press uses a small piston with an area of 2 square inches and a large piston with an area of 20 square inches. If you apply 100 pounds of force to the small piston, what force does the large piston exert?
Answer: 1,000 pounds
Pascal's Law states that pressure applied to a confined fluid is transmitted equally in all directions. Pressure = 100 lb ÷ 2 in² = 50 PSI. Force on large piston = 50 PSI × 20 in² = 1,000 pounds. This mechanical advantage is the fundamental principle behind hydraulic presses.
In a pneumatic system, what is the primary purpose of an air dryer or desiccant filter installed after the compressor?
Answer: To remove moisture that could cause corrosion and component damage
When air is compressed, water vapor condenses into liquid water. This moisture can corrode metal components, wash away lubricants, freeze in cold environments, and contaminate pneumatic tools. Air dryers and desiccant filters remove this moisture to protect downstream equipment and ensure reliable operation.
A single-acting hydraulic cylinder extends when pressurized but relies on an external force or spring to retract. Which application is this type of cylinder BEST suited for?
Answer: A dump truck bed that gravity will lower after hydraulic lift
Single-acting cylinders only produce force in one direction (extension). A dump truck bed is ideal because hydraulic pressure raises the bed, and gravity alone provides sufficient force to lower it when the valve is opened to release pressure. Applications requiring powered force in both directions need double-acting cylinders.
Which property of hydraulic fluid is MOST critical to maintaining consistent system performance across a wide range of operating temperatures?
Answer: Viscosity index
Viscosity index (VI) measures how much a fluid's viscosity changes with temperature. A high VI means the fluid maintains relatively stable thickness whether cold or hot. If viscosity drops too much when hot, the fluid leaks past seals and loses its load-carrying ability; if too thick when cold, it won't flow properly at startup. All other listed properties are less directly related to performance consistency across temperatures.
In a pneumatic circuit, a 4/2 directional control valve is specified. What do the numbers 4 and 2 represent?
Answer: 4 ports and 2 switching positions
Directional control valve nomenclature uses a number/number format where the first number indicates the number of ports (connections for supply, exhaust, and actuator lines) and the second number indicates the number of switching positions (states the valve can be placed in). A 4/2 valve has 4 ports and 2 positions, commonly used to extend and retract a double-acting cylinder.
A hydraulic system is operating normally, but the actuator begins moving slower than specified even though pump flow rate is unchanged. Which fault is MOST likely causing this?
Answer: An internal leak has developed in the hydraulic cylinder
An internal leak in the cylinder (past the piston seals) allows pressurized fluid to bypass from the high-pressure side to the low-pressure side without doing useful work. This reduces the effective flow moving the piston, slowing actuator speed even though the pump is delivering full flow. The other options would not typically cause gradual speed reduction while all other parameters remain normal.