Practice Test GeeksMASS Test Practice Test
← All MASS Flashcard Decks

Technical Reading Comprehension Flashcards

7 cards from real MASS practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Technical Reading Comprehension flashcards as text

  1. A maintenance manual states: "Disconnect the power supply before removing the access panel." What must be done first?

    Answer: Disconnect the power supply

    The instruction specifies disconnecting power before any panel removal.

  2. A safety data sheet reads: "In case of skin contact, rinse immediately with plenty of water for at least 15 minutes." What is the minimum rinse time?

    Answer: 15 minutes

    The sheet states a minimum of 15 minutes of rinsing.

  3. A procedure says: "Tighten all bolts to 25 Nm, then re-check after the engine has cooled." When should bolts be re-checked?

    Answer: After the engine has cooled

    Re-checking occurs after the engine has cooled, per the instruction.

  4. A label warns: "Do not exceed a load of 500 kg." A 520 kg load is placed on the equipment. This action is:

    Answer: Over the limit

    520 kg exceeds the stated 500 kg maximum.

  5. A diagram caption states: "Valve A controls coolant flow; Valve B controls fuel flow." To stop coolant, which valve is used?

    Answer: Valve A

    Valve A controls coolant flow.

  6. A manual reads: "If the warning light flashes, stop the machine and contact a supervisor." A flashing light requires you to:

    Answer: Stop and contact a supervisor

    A flashing light directs you to stop and contact a supervisor.

  7. Instructions state: "Apply lubricant only to the inner bearing, not the outer housing." Lubricant should be applied to:

    Answer: The inner bearing

    Lubricant goes only on the inner bearing.