Water Supply and Distribution Flashcards
6 cards from real IPC practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 6 Water Supply and Distribution flashcards as text
A new building's water service pipe is being installed in a region with a known frost line depth of 18 inches. According to the IPC, what is the minimum required burial depth for this pipe to prevent freezing?
Answer: At least 12 inches below grade and at least 6 inches below the frost line.
IPC Section 305.4 specifies that water service piping must be installed at least 12 inches deep and at least 6 inches below the frost line. This ensures protection from both surface activities and freezing temperatures. In this scenario, being 6 inches below the 18-inch frost line means the pipe must be at least 24 inches deep, which satisfies both conditions.
In a residential building, the static water pressure from the municipal supply is measured at 95 psi. What action is required by the IPC to be taken on the water distribution system?
Answer: Install a pressure-reducing valve.
According to IPC Section 604.8, if the static water pressure is greater than 80 psi, an approved pressure-reducing valve must be installed to reduce the pressure in the building's distribution system to 80 psi or less.
When installing a temperature and pressure (T&P) relief valve discharge pipe for a water heater, which of the following is an IPC requirement for the termination point?
Answer: The termination point must be located in a manner that prevents scalding of occupants.
IPC Section 504.6 details the requirements for T&P relief valve discharge pipes. A key safety requirement is that the discharge must be directed to a location, such as a floor drain or an indirect waste receptor, and terminate in a way that prevents injury or scalding to building occupants. It must not be capped or directly connected to the drainage system. The maximum termination height is 6 inches above the floor or receptor.
A plumber is hydrostatically testing a newly installed potable water supply system. According to the IPC, what is the minimum required test pressure and duration?
Answer: 1.5 times the working pressure, but not less than 100 psi, for 15 minutes.
IPC Section 312.5 requires that upon completion, a potable water supply system shall be tested and proved tight. The system must be tested hydrostatically to not less than 1.5 times the working pressure, but not less than 100 psi. The test must be maintained for at least 15 minutes without any leakage.
Which of the following locations is mandated by the IPC for the installation of water hammer arrestors?
Answer: Where quick-closing valves are installed.
IPC Section 604.9 requires that the water distribution system be provided with water hammer arrestors where quick-closing valves (such as those on clothes washers, dishwashers, or single-lever faucets) are installed. This is to absorb the hydraulic shock and prevent damage to pipes and fixtures.
To protect the potable water supply from contamination, a potable water inlet to a gravity storage tank must be terminated with an air gap. What is the minimum air gap dimension required by the IPC?
Answer: 4 inches (102 mm) above the flood level rim of the overflow.
IPC Section 606.5.6 specifies that potable water inlets to gravity tanks must be controlled by a fill valve and the inlet must terminate so as to provide an air gap of not less than 4 inches above the overflow.