InterNACHI - International Association of Certified Home Inspectors Roofing Systems and Components Questions and Answers

Question 1

During a roof inspection, you observe a chimney on a sloped roof that is 36 inches wide. What component should be present to properly divert water around the chimney, especially in climates with snow and ice?

Accepted Answer

A cricket or saddle

Answer

For chimneys wider than 30 inches, a cricket (or saddle) is required to be installed on the high side of the chimney to divert water, snow, and ice, preventing ponding and potential leaks.

Question 2

Which of the following attic ventilation systems relies on wind and natural convection (the principle that hot air rises) to function, without mechanical assistance?

Accepted Answer

Ridge and soffit vents

Answer

Ridge and soffit vents are components of a passive ventilation system. Soffit vents act as intakes for cooler, lower air, while ridge vents serve as exhausts for hotter air that rises to the peak of the attic, creating continuous airflow without any mechanical parts.

Question 3

According to most manufacturers and building codes, what is the absolute minimum slope on which standard asphalt shingles can be installed, provided special underlayment techniques are used?

Accepted Answer

2:12

Answer

The absolute minimum slope for asphalt shingle installation is 2:12 (2 inches of vertical rise for every 12 inches of horizontal run). Roofs with slopes between 2:12 and 4:12 require special application techniques, such as a double layer of underlayment, to prevent leaks from wind-driven rain and ice damming.

Question 4

A home inspector is examining a low-slope roof with a modified bitumen covering. The inspector notes several areas of 'ponding water.' According to the National Roofing Contractors Association (NRCA), ponding water is generally considered a potential issue if it remains on the roof for more than how long after a rain event?

Accepted Answer

48 hours

Answer

The NRCA defines ponding water as water that remains on a roof surface for more than 48 hours after rainfall, under conditions conducive to drying. Prolonged ponding can accelerate the deterioration of roofing materials.

Question 5

While inspecting the junction of a roof plane and a vertical sidewall, an inspector should look for which type of flashing to be interwoven with the shingle courses?

Accepted Answer

Step flashing

Answer

Step flashing consists of individual pieces of metal installed with each course of shingles and bent to go up the adjacent vertical wall. This method is critical for preventing water intrusion at roof-to-wall intersections.

(InterNACHI) International Association of Certified Home Inspectors Practice Test

(InterNACHI) International Association of Certified Home Inspectors Practice Test

InterNACHI - International Association of Certified Home Inspectors Roofing Systems and Components Questions and Answers