IEC Service and Load Calculations 3

Question 1

A 240-volt, 30-ampere clothes dryer circuit is installed in a dwelling. What minimum load must be used for service calculation per NEC 220.54?

Accepted Answer

5,000 VA

Answer

NEC 220.54 requires each dryer to be calculated at 5,000 watts or the nameplate rating, whichever is larger.

Question 2

In a standard residential load calculation, small appliance branch circuit loads are added at what VA per circuit?

Accepted Answer

1,500 VA

Answer

NEC 220.52(A) requires 1,500 VA per 20-ampere small appliance branch circuit in the kitchen, dining, and pantry areas.

Question 3

What is the NEC-required number of minimum small appliance branch circuits for a dwelling unit kitchen?

Accepted Answer

Two 20-ampere circuits

Answer

NEC 210.11(C)(1) requires at least two 20-ampere small appliance branch circuits for the kitchen, dining, and pantry areas.

Question 4

When calculating the service load for four household clothes dryers in an apartment building, what demand factor does NEC Table 220.54 apply?

Accepted Answer

80%

Answer

NEC Table 220.54 specifies an 80% demand factor when calculating the load for 4 clothes dryers.

Question 5

Under the NEC optional method for dwelling units (220.82), what percentage is applied to the load above the initial 10 kVA?

Accepted Answer

40%

Answer

NEC 220.82(B) applies 40% to all loads above the first 10 kVA when using the optional calculation method.

IEC - Independent Electrical Contractors Practice Test