ICC Building Inspection 2

Question 1

During a framing inspection, which of the following would NOT typically be verified by the inspector?

Accepted Answer

Quality of paint applied to exposed framing

Answer

Paint application is a cosmetic concern and is not part of a framing inspection, which focuses on structural integrity, fire blocking, and code compliance.

Question 2

Under the IRC, floor joists must be doubled under which of the following conditions?

Accepted Answer

Non-bearing partitions running perpendicular to the joists

Answer

The IRC requires floor joists to be doubled under non-bearing partitions running perpendicular to the joists to properly distribute the concentrated load.

Question 3

What is the minimum bearing length required for rafters and ceiling joists at their point of support, per the IRC?

Accepted Answer

1.5 inches

Answer

The IRC requires rafters and ceiling joists to bear a minimum of 1.5 inches at their support point to ensure adequate load transfer.

Question 4

What is the primary purpose of fireblocking in wood-frame construction?

Accepted Answer

Prevent the spread of fire through concealed spaces in walls and floors

Answer

Fireblocking is designed to prevent fire from traveling through concealed wall and floor cavities that could otherwise act as chimneys and accelerate fire spread.

Question 5

An inspector discovers that a contractor installed a beam that does not match the approved construction drawings. What is the inspector's appropriate first action?

Accepted Answer

Issue a notice of violation and stop work until the discrepancy is formally resolved

Answer

When work does not conform to approved construction documents, the inspector must issue a notice of violation and require that work stop until the discrepancy is resolved through official channels.

(ICC) International Code Council Practice Test

(ICC) International Code Council Practice Test

ICC Building Inspection 2