Gold Design Gold Jewelry Techniques 1 — Questions and Answers
Question 1: What jewelry-making technique involves hammering gold into thin sheets used to cover a base material?
- Gold plating
- Gold leafing (Correct answer)
- Gold filling
- Gold vermeil
Correct answer: Gold leafing
Gold leafing involves hammering gold into extremely thin sheets that are then applied to a surface.
Question 2: Which technique involves fusing small beads of gold onto a gold surface to create a textured pattern?
- Filigree
- Granulation (Correct answer)
- Repoussé
- Chasing
Correct answer: Granulation
Granulation is an ancient technique of fusing tiny gold beads to a metal surface without visible solder.
Question 3: What metalsmithing process uses a punch and hammer from the back of a gold sheet to create raised designs?
- Engraving
- Chasing
- Repoussé (Correct answer)
- Die striking
Correct answer: Repoussé
Repoussé is the technique of creating raised relief designs by hammering from the reverse side of the metal.
Question 4: Which gold fabrication method involves twisting fine gold wire into intricate lace-like patterns?
- Filigree (Correct answer)
- Granulation
- Enameling
- Cloisonné
Correct answer: Filigree
Filigree uses twisted fine gold wire soldered together into ornate open designs.
Question 5: What process involves pouring molten gold into a mold, often using a wax model that is melted out?
- Forging
- Lost-wax casting (Correct answer)
- Die striking
- Electroforming
Correct answer: Lost-wax casting
Lost-wax casting (cire perdue) uses a wax model that is encased in investment, then melted out before molten gold is poured in.
Question 6: Which technique deposits a thin layer of gold onto another metal using an electric current?
- Gold leafing
- Gold vermeil
- Electroplating (Correct answer)
- Gold filling
Correct answer: Electroplating
Electroplating uses electrical current to deposit a thin layer of gold ions onto a base metal surface.
Gold Design Gold Jewelry Techniques 1
What jewelry-making technique involves hammering gold into thin sheets used to cover a base material?