Practice Test Geeks(GMI) Graphic Measures International Certification Practice Test
← All GMI Flashcard Decks

Implementation & Configuration Flashcards

7 cards from real GMI practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Implementation & Configuration flashcards as text

  1. A print facility is configuring its workflow for GRACoL 2013 compliance. Which substrate category does GRACoL 2013 primarily target?

    Answer: Coated #1 gloss paper

    GRACoL 2013 (General Requirements for Applications in Commercial Offset Lithography) primarily targets coated #1 gloss paper used in high-quality commercial printing.

  2. In configuring the black ink generation for a CMYK press profile, what does 'GCR' (Gray Component Replacement) accomplish?

    Answer: It replaces chromatic inks with black ink in neutral and near-neutral areas

    GCR replaces the gray component formed by CMY ink combinations with an equivalent amount of black ink, reducing total ink coverage and improving color stability.

  3. During soft proofing configuration for a GMI workflow, which display adaptation must be enabled for accurate on-screen simulation of the printed substrate?

    Answer: Paper color and black point simulation

    Paper color and black point simulation must be enabled in soft proofing to accurately display how the substrate white and minimum ink density will appear in the final print.

  4. When configuring ink density targets for a 4-color process job under GMI standards, which instrument reading is used to measure solid ink density?

    Answer: Status T or Status E densitometric reading

    Solid ink density is measured using a densitometer set to Status T (Americas) or Status E (Europe) response, providing a single-number density value for each ink.

  5. A new inkjet proofer is being configured in a GMI workflow. What is the correct sequence of steps after hardware installation?

    Answer: Calibrate → Linearize → Profile → Verify

    The correct sequence is: calibrate hardware (media/ink setup) → linearize → build ICC profile → verify output against the target standard.

  6. In the context of GMI implementation, what is the function of a 'press characterization data set' (PCDS)?

    Answer: A standardized set of measurement data describing a printing condition, used as a profile-building reference

    A press characterization data set (PCDS) is a standardized collection of spectral measurements from a reference printing condition, used to build ICC profiles and establish benchmarks.

  7. When configuring tone reproduction curves (TRC) for a digital press to meet GMI targets, which tonal region typically requires the MOST aggressive compensation?

    Answer: Midtones (40–60%)

    The midtone region (40–60%) typically exhibits the most dot gain on press and therefore requires the most aggressive TRC compensation to hit target density and L* values.