Free STSC Cranes, Derricks, Hoists, and Rigging Safety Questions and Answers 1

Question 1

A signal person is required for a crane lift when:

Accepted Answer

The point of operation is not in full view of the operator

Answer

OSHA 1926.1419(a) requires a signal person when the point of operation is not in full view of the operator, when the operator's view is obstructed in the direction the equipment is traveling, or when either the operator or the person handling the load determines that a signal person is needed. This ensures constant communication and hazard awareness during the lift.

Question 2

What is the minimum required clearance from a 50kV power line when operating a crane?

Accepted Answer

10 feet

Answer

According to OSHA 1926.1408 Table A, for power lines with a voltage up to 50kV, the minimum clearance distance that must be maintained is 10 feet. This distance increases as the voltage of the power line increases. Maintaining this 'circle of safety' is a fundamental rule to prevent electrical arcing and electrocution.

Question 3

Who is primarily responsible for ensuring the ground conditions at a construction site are firm, drained, and graded sufficiently to support the crane?

Accepted Answer

The controlling entity

Answer

OSHA 1926.1402(b) states that the controlling entity (e.g., the general contractor) has the primary responsibility to provide adequate ground conditions. The crane operator, however, retains the authority to stop work if they believe the ground conditions are unsafe.

Question 4

How often must rigging equipment, such as slings and shackles, be inspected?

Accepted Answer

Prior to use on each shift

Answer

OSHA 1926.251(a)(1) requires that rigging equipment be inspected prior to use on each shift and as necessary during its use to ensure it is safe. Any equipment found to be defective must be immediately removed from service. This frequent inspection is critical for preventing rigging failure.

Question 5

What is the primary purpose of using tag lines during a lift?

Accepted Answer

To control the load and prevent rotation

Answer

Tag lines are ropes attached to a load that are used by ground personnel to control the load's movement. Their main purpose is to prevent the load from swinging or rotating uncontrollably, which could cause it to strike workers or objects, especially in windy conditions.

(STSC) Safety Trained Supervisor Construction Practice Test

(STSC) Safety Trained Supervisor Construction Practice Test

Free STSC Cranes, Derricks, Hoists, and Rigging Safety Questions and Answers 1