SAW Welding Techniques & Process Control 1

Question 1

Which technique ensures uniform weld bead formation in SAW?

Accepted Answer

Constant travel speed with proper alignment

Answer

To ensure uniform weld bead formation in SAW, it is crucial to maintain a constant travel speed and proper alignment of the electrode with the joint. Consistent speed ensures a steady heat input and deposition rate, while correct alignment ensures the weld metal is deposited evenly within the joint. This leads to a smooth, uniform bead with consistent penetration and profile.

Question 2

What effect does excessive arc voltage have on SAW welds?

Accepted Answer

Results in undercut and excessive spatter

Answer

Excessive arc voltage in SAW creates a longer, wider arc, which can lead to several weld defects. It often results in undercut, where the base metal along the toe of the weld is melted away without being filled by weld metal, and excessive spatter, which is molten metal expelled from the weld pool. It can also cause a wider, flatter bead with reduced penetration.

Question 3

Why is it important to control heat input in SAW?

Accepted Answer

To manage weld quality and prevent defects

Answer

Controlling heat input in SAW is critical because it directly influences the metallurgical properties and overall quality of the weld. Excessive heat input can lead to grain coarsening in the heat-affected zone (HAZ), increased distortion, and reduced mechanical properties, while insufficient heat input can cause lack of fusion and inadequate penetration. Proper heat input management prevents these defects and ensures the weld meets specified strength and toughness requirements.

Question 4

Which defect is caused by poor flux coverage during SAW?

Accepted Answer

Porosity

Answer

Poor flux coverage in SAW means the molten weld pool is inadequately shielded from the surrounding atmosphere. This allows atmospheric gases like oxygen and nitrogen to dissolve into the molten metal, and as the weld solidifies, these trapped gases form small voids or bubbles. This results in porosity, a common weld defect that weakens the joint.

Question 5

What adjustment improves fusion when welding thicker materials?

Accepted Answer

Increase amperage

Answer

When welding thicker materials, more heat is required to achieve proper fusion and penetration into the base metal. Increasing the amperage (welding current) directly increases the heat input at the arc, leading to deeper melting and better fusion with the thicker material. This ensures a strong and sound weld that fully penetrates the joint.

(SAW) Submerged Arc Welding Certification Practice Test

(SAW) Submerged Arc Welding Certification Practice Test

SAW Welding Techniques & Process Control 1