Free CPSI Specific Equipment Standards for Swings and Slides Questions and Answers 1

Question 1

According to ASTM F1487, what is the requirement for the closure of an S-hook on a swing?

Accepted Answer

The gap must be no larger than 0.04 inches.

Answer

ASTM F1487 specifies that S-hooks must be closed to prevent entanglement hazards. The gap should not be greater than 0.04 inches, which is approximately the thickness of a dime. This prevents clothing toggles or drawstrings from catching on the hook.

Question 2

For a slide with a platform height of 6 feet, what is the acceptable range for the height of the slide chute exit region above the protective surfacing?

Accepted Answer

Between 7 inches and 15 inches.

Answer

For slides with a platform height greater than 48 inches (4 feet), ASTM F1487 requires the exit region height to be between 7 and 15 inches above the protective surfacing. This range ensures a safe transition from sliding to a standing or seated position without being too high to cause injury or too low to cause an abrupt stop.

Question 3

What is the minimum required distance between two adjacent to-fro swing seats (e.g., belt swings) in the same bay?

Accepted Answer

24 inches.

Answer

ASTM F1487 requires a minimum of 24 inches between adjacent swing seats. This spacing prevents children on adjacent swings from colliding with each other during use. Proper spacing is crucial for preventing impact injuries.

Question 4

For a slide with a chute that is 30 inches wide, what is the minimum required height for the sidewalls along the sliding portion?

Accepted Answer

4.0 inches.

Answer

The minimum height of the sidewalls for a slide chute is 4.0 inches, regardless of the slide's width or slope. This standard ensures that a user is contained within the slide chute and reduces the risk of falling off the side.

Question 5

What is the maximum opening size permitted for a link in a swing chain to prevent finger entrapment?

Accepted Answer

The opening must not admit a 0.31-inch diameter rod.

Answer

To prevent finger entrapment, ASTM F1487 specifies that openings in swing chains must not allow the passage of a 0.31-inch (5/16-inch) diameter rod. This is based on the size of a child's finger, preventing it from getting caught and causing injury.

CPSI - Certified Playground Safety Inspector Practice Test

CPSI - Certified Playground Safety Inspector Practice Test

Free CPSI Specific Equipment Standards for Swings and Slides Questions and Answers 1