FREE CPSI Surfacing Requirements and Impact Attenuation Testing Questions and Answers

Question 1

What does the 'critical height' of a playground surfacing material represent according to ASTM F1292?

Accepted Answer

The fall height below which a life-threatening head injury would not be expected to occur.

Answer

Critical height is a performance specification that represents the fall height below which a life-threatening head injury is not expected. It is determined by testing the surfacing material's ability to absorb impact energy, ensuring the G-max and HIC values remain below specified thresholds. This rating helps ensure the chosen surface is appropriate for the fall height of the adjacent play equipment.

Question 2

During an impact attenuation test following ASTM F1292, what are the maximum allowable values for G-max and Head Injury Criterion (HIC)?

Accepted Answer

G-max of 200 and HIC of 1000

Answer

ASTM F1292 specifies that for a surfacing material to pass the impact attenuation test, the peak G-max must not exceed 200, and the Head Injury Criterion (HIC) must not exceed 1000. These values are based on research into survivable head impact forces. Exceeding these thresholds indicates a higher risk of a life-threatening head injury.

Question 3

For a stationary piece of equipment with a designated play surface 6 feet high, what is the minimum required extent of the protective surfacing in the use zone?

Accepted Answer

6 feet in all directions.

Answer

According to the CPSC Handbook and ASTM F1487, the use zone for most stationary equipment should extend a minimum of 6 feet (72 inches) in all directions from the perimeter of the equipment. This area must be filled with appropriate protective surfacing to cushion a fall. The 6-foot rule is a fundamental requirement for most stationary play structures.

Question 4

An inspector notes that the engineered wood fiber (EWF) surfacing under a slide has been displaced, creating a 'dished out' area where the depth is only 4 inches, while the required maintained depth is 9 inches. What is the most appropriate action?

Accepted Answer

Recommend raking the existing EWF from other areas to restore the 9-inch depth and increase inspection frequency.

Answer

Loose-fill surfacing materials like EWF are prone to displacement in high-traffic areas. The correct maintenance procedure is to rake the material back into place to maintain the required depth and ensure proper impact attenuation. This should be a frequent task in any playground maintenance program.

Question 5

ASTM F1292 requires impact attenuation testing to be performed at what temperature conditions?

Accepted Answer

At three different temperatures representing cold, ambient, and hot conditions.

Answer

ASTM F1292 requires testing at three distinct temperatures (e.g., approximately 25°F, 72°F, and 120°F) to evaluate the surfacing's performance across a range of environmental conditions. Some materials can become harder and less shock-absorbing in the cold, or softer in the heat. Testing at these three temperatures ensures the material provides adequate protection year-round.

CPSI - Certified Playground Safety Inspector Practice Test

CPSI - Certified Playground Safety Inspector Practice Test

FREE CPSI Surfacing Requirements and Impact Attenuation Testing Questions and Answers