Free CPSI Protective Surfacing Requirements Questions and Answers 1

Question 1

A CPSI is inspecting a new playground installation. The highest designated play surface is a platform at 8 feet. The owner provides documentation showing the poured-in-place rubber surfacing has a critical height of 8 feet, as tested in a laboratory according to ASTM F1292. Which of the following is the MOST accurate assessment of this situation?

Accepted Answer

The surfacing's critical height must exceed the fall height to provide a margin of safety.

Answer

While the surfacing technically meets the minimum requirement where the critical height equals the fall height, best practice and a conservative approach to safety recommend a margin for error. Surfacing performance can be affected by factors like installation, weather, and wear. Therefore, selecting a surface with a critical height that exceeds the highest fall height provides an essential safety margin.

Question 2

According to ASTM F1292, the performance of a protective surface is determined by measuring its impact attenuation. What are the two key performance criteria measured during this test?

Accepted Answer

Peak deceleration (G-max) and Head Injury Criterion (HIC)

Answer

ASTM F1292 specifies that a surface's ability to absorb impact is measured by dropping an instrumented headform and recording two values: the peak deceleration (G-max), which cannot exceed 200 g's, and the Head Injury Criterion (HIC), which cannot exceed a score of 1000. These two measures together determine the critical height of the surface.

Question 3

A playground has a single-axis belt swing set where the pivot point is 8 feet above the protective surfacing. What is the minimum required dimension of the use zone in front of and behind the swings?

Accepted Answer

16 feet

Answer

The CPSC Handbook and ASTM F1487 require the use zone for a single-axis swing to extend a minimum distance of twice the height of the pivot point from the protective surfacing, both in front of and behind the swing. In this case, 2 times 8 feet equals 16 feet.

Question 4

Which of the following surfaces is considered unacceptable for use as a protective surface within the use zone of playground equipment according to the CPSC Handbook?

Accepted Answer

Compacted Earth and Grass

Answer

The CPSC Public Playground Safety Handbook explicitly lists surfaces like concrete, blacktop, packed earth, and grass as unacceptable for use zones of play equipment because they do not provide the necessary shock-absorbing (impact attenuating) properties to protect against serious head injuries from falls.

Question 5

A CPSI is evaluating two adjacent stationary play structures. The designated play surface of the first structure is 24 inches high, and the adjacent surface of the second structure is 36 inches high. According to CPSC guidelines, what is the minimum required distance between these two structures?

Accepted Answer

9 feet, because one of the structures is over 30 inches high.

Answer

When two adjacent pieces of equipment have designated play surfaces over 30 inches in height, their use zones cannot overlap and must be separated by a minimum of 9 feet. Since one platform is at 36 inches, the 9-foot requirement applies to prevent collision or interference between users of the separate structures.

CPSI - Certified Playground Safety Inspector Practice Test

CPSI - Certified Playground Safety Inspector Practice Test

Free CPSI Protective Surfacing Requirements Questions and Answers 1