Free CEM Test Boiler and Steam Systems Questions and Answers

Question 1

An energy manager reviewing boiler operations notices a gradual increase in stack gas temperature over several months, even though the firing rate and excess air levels have remained consistent. What is the most likely cause of this change?

Accepted Answer

Fouling of heat transfer surfaces inside the boiler.

Answer

A gradual increase in stack temperature under constant load and excess air conditions typically indicates that heat is not being transferred effectively from the combustion gases to the water. This is most often caused by the buildup of soot on the fireside or scale on the waterside of the boiler tubes, which acts as an insulator and reduces heat transfer efficiency.

Question 2

What is the primary purpose of continuous (or surface) blowdown in a boiler system?

Accepted Answer

To control the concentration of Total Dissolved Solids (TDS) in the boiler water.

Answer

Continuous blowdown removes a small, constant amount of water from near the surface of the boiler water, where dissolved solids are most concentrated. Its main function is to control the level of Total Dissolved Solids (TDS) to prevent foaming, priming, and carryover of boiler water into the steam system. Bottom blowdown, in contrast, is used to remove sludge and settled solids.

Question 3

An auditor is inspecting a steam distribution system and suspects a particular steam trap has failed in the open position. Which of the following observations would most strongly confirm this suspicion?

Accepted Answer

A large, continuous plume of live steam is visibly venting from a nearby condensate receiver tank.

Answer

A steam trap that has failed open will continuously pass live steam, not just condensate, into the return system. This high-energy steam travels to the condensate receiver, where it is often vented to the atmosphere, creating a large, wasteful, and highly visible plume of steam. A cool downstream pipe or under-heated equipment would suggest a trap has failed closed, blocking flow.

Question 4

A boiler's flue gas economizer improves overall system efficiency by performing which of the following functions?

Accepted Answer

Transferring waste heat from the flue gas to the incoming boiler feedwater.

Answer

A flue gas economizer is a heat exchanger installed in the boiler's stack that captures residual heat from the exiting flue gases. This captured heat is then transferred to the relatively cool boiler feedwater on its way to the boiler drum, preheating it and reducing the amount of fuel needed to turn it into steam.

Question 5

Which of the following is a significant negative consequence of having too much excess air in the boiler combustion process?

Accepted Answer

Decreased boiler efficiency due to excess heat being carried up the stack.

Answer

While a certain amount of excess air is necessary for complete and safe combustion, too much excess air reduces efficiency. The excess nitrogen and oxygen do not participate in combustion but are heated to the flue gas temperature, carrying a significant amount of thermal energy away and exhausting it up the stack instead of transferring it to the water.

(CEM) Certified Emergency Manager Practice Test

(CEM) Certified Emergency Manager Practice Test

Free CEM Test Boiler and Steam Systems Questions and Answers