Fireguard F-01 Fire Safety Hot Work Operations 3

Question 1

After hot work is completed for the day, who should be notified if the building has a security or fire watch presence overnight?

Accepted Answer

The building's security or overnight fire watch personnel, with the permit on record

Answer

Only the general contractor's project manager

Answer

The local FDNY fire company by calling 911

Answer

No notification is required once the 30-minute fire watch period ends

Question 2

Can a fire watch personnel also serve as the person performing the hot work simultaneously?

Accepted Answer

No, the fire watch must be a separate dedicated individual

Answer

Yes, if the operator is experienced enough to watch both tasks

Answer

Yes, as long as work stops every 10 minutes for an inspection

Answer

Only if the work area is smaller than 100 square feet

Question 3

What action should a fire watch take if a fire is discovered during or after hot work operations?

Accepted Answer

Immediately attempt to extinguish it if small, activate the fire alarm, and call the fire department

Answer

Wait for the work operator to finish before sounding an alarm

Answer

Only notify the building superintendent and document the incident

Answer

Evacuate the immediate area but take no further action

Question 4

Hot work on a metal container that previously held flammable material requires what special precaution before work begins?

Accepted Answer

The container must be purged, cleaned, and tested to confirm it is free of flammable residue or vapors

Answer

Simply rinsing the container with water is sufficient

Answer

Welding can proceed if the container is left open during work

Answer

A secondary container must be placed inside the first one

Question 5

Under NYC Fire Code, who is typically responsible for issuing a hot work program and ensuring compliance in a building?

Accepted Answer

The building owner or a designated hot work program manager

Answer

The building's tenant performing the hot work

Answer

The NYC Department of Buildings inspector

Answer

The FDNY engine company serving that district

Question 6

What should be done with the hot work permit once the work and post-work fire watch are fully completed?

Accepted Answer

It should be retained and filed as a record for a required period

Answer

It should be discarded immediately to avoid liability

Answer

It should be returned to the FDNY district office by end of day

Answer

It should be posted permanently at the location where work occurred

Question 7

Which trade commonly performs hot work that requires a Fireguard to be familiar with its fire hazards?

Accepted Answer

Welders and pipefitters using torch cutting or arc welding

Answer

Plumbing pipe installation using threaded fittings only

Answer

Electricians pulling wire through conduit

Answer

Carpenters installing wood flooring