Personal Protective Equipment Flashcards
7 cards from real Firefighter practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 7 Personal Protective Equipment flashcards as text
What layer of turnout gear is designed to keep water and chemicals out while allowing perspiration vapor to escape?
Answer: Moisture barrier
The moisture barrier blocks liquids while permitting some vapor transfer for cooling.
How often should SCBA cylinders be hydrostatically tested for steel and aluminum types?
Answer: Every 5 years
Steel and aluminum SCBA cylinders require hydrostatic testing every 5 years.
What does reflective trim on turnout gear primarily provide?
Answer: Visibility in low-light conditions
Reflective trim increases the firefighter's visibility to others in smoke and darkness.
Which of the following is the correct sequence concern when donning SCBA and facepiece?
Answer: Facepiece before activating air supply seal check
The facepiece must be donned and seal-checked before air flow to confirm a tight seal.
What is a major risk of wearing PPE that is too large or loosely fitted?
Answer: Reduced protection and snag hazards
Loose gear can expose skin to heat and create snag hazards during operations.
What is the purpose of a drag rescue device (DRD) built into turnout coats?
Answer: Allow a downed firefighter to be pulled to safety
The DRD is a built-in harness loop used to drag an incapacitated firefighter out of danger.
Why should firefighters avoid wearing synthetic clothing under turnout gear?
Answer: It can melt and cause severe burns
Synthetic fabrics can melt onto skin under high heat, worsening burn injuries.