F04 Temporary Place of Assembly Rules 3 — Questions and Answers
Question 1: What action must a Fireguard take if the maximum occupant load of a temporary place of assembly is reached?
- Stop all further entry and refuse additional guests until occupants leave (Correct answer)
- Notify the promoter and allow a 10% overage
- Permit entry only to ticketed guests above the limit
- Contact FDNY and wait for instructions before stopping entry
Correct answer: Stop all further entry and refuse additional guests until occupants leave
Once the maximum occupant load is reached, the Fireguard must stop further entry and prevent overcrowding to comply with the posted occupancy limit.
Question 2: What is the minimum width required for main aisles in a temporary place of assembly seating arrangement?
- 44 inches (Correct answer)
- 24 inches
- 30 inches
- 60 inches
Correct answer: 44 inches
Main aisles in a place of assembly must be at least 44 inches wide to allow safe and rapid egress during an emergency.
Question 3: What type of lighting is mandatory for emergency egress paths in a temporary place of assembly?
- Emergency lighting that activates automatically upon power failure (Correct answer)
- Standard overhead lighting on a dimmer
- Portable flashlights carried only by staff
- Strobe lights to alert occupants
Correct answer: Emergency lighting that activates automatically upon power failure
Emergency egress lighting that activates automatically upon power failure is required to illuminate exit paths and ensure safe evacuation.
Question 4: Which of the following seating arrangements requires a fire safety inspection before use at a temporary place of assembly?
- Temporary bleacher or riser seating (Correct answer)
- Fixed permanently installed theater seats
- Individual folding chairs in rows under 49 people
- Outdoor lawn seating with no structures
Correct answer: Temporary bleacher or riser seating
Temporary bleacher or riser seating presents structural and egress risks and must be inspected before it is approved for use in a temporary assembly.
Question 5: What must a Fireguard do FIRST when a fire alarm activates during a crowded temporary place of assembly event?
- Begin an orderly evacuation of all occupants immediately (Correct answer)
- Investigate the source of the alarm before evacuating
- Announce that it is likely a false alarm to prevent panic
- Call the building owner before taking any action
Correct answer: Begin an orderly evacuation of all occupants immediately
Upon activation of a fire alarm, the Fireguard must initiate an orderly evacuation immediately without first investigating, as any delay can cost lives.
Question 6: What is the maximum distance a person should have to travel to reach an exit in a temporary place of assembly?
- 200 feet (Correct answer)
- 500 feet
- 100 feet
- 75 feet
Correct answer: 200 feet
Travel distance to an exit in a place of assembly generally must not exceed 200 feet to ensure occupants can evacuate quickly in an emergency.
Question 7: At a temporary outdoor tent assembly, where must exits be located?
- At opposite ends or sides of the tent to allow egress in multiple directions (Correct answer)
- Only at the main entrance used for admission
- Wherever the event promoter finds most convenient
- Only along one side wall of the tent
Correct answer: At opposite ends or sides of the tent to allow egress in multiple directions
Exits must be located at multiple, opposing sides or ends of a tent to ensure that occupants can escape regardless of where a fire or hazard originates.
F04 Temporary Place of Assembly Rules 3
What action must a Fireguard take if the maximum occupant load of a temporary place of assembly is reached?