F-02 Fireguard Fire Protection Systems 3 — Questions and Answers
Question 1: Under NYC Fire Code, how often must a Fireguard with an F-02 certificate of fitness inspect the fire protection systems in their building?
- Once per week
- Once per month
- At least once every 24 hours when the building is occupied (Correct answer)
- Only when a fire occurs
Correct answer: At least once every 24 hours when the building is occupied
F-02 Fireguards are required to inspect fire protection systems at least once every 24 hours during periods of occupancy.
Question 2: A tamper switch on a sprinkler control valve is used to:
- Test the sprinkler heads for proper operation
- Detect and signal when a valve has been moved from its normal position (Correct answer)
- Measure water pressure in the system
- Drain residual water from the piping
Correct answer: Detect and signal when a valve has been moved from its normal position
Tamper switches monitor valve positions and send an alarm signal to the fire alarm panel if a valve is moved from its fully open position.
Question 3: Which class of standpipe system provides hose connections for occupant use AND fire department connections?
- Class I
- Class II
- Class III (Correct answer)
- Class IV
Correct answer: Class III
Class III standpipes combine both 2½-inch fire department connections and 1½-inch hose connections for occupant use.
Question 4: What action should a Fireguard take FIRST upon discovering a sprinkler head has been accidentally damaged?
- Replace the sprinkler head immediately without notifying anyone
- Notify the FDNY and building management immediately (Correct answer)
- Cover the opening with tape to prevent water discharge
- Increase system water pressure to compensate
Correct answer: Notify the FDNY and building management immediately
Damaged sprinkler heads compromise fire protection and must be reported immediately to FDNY and building management so proper repairs can be made.
Question 5: In a fire alarm system, what is the function of a 'pull station'?
- It pulls water from the municipal supply into the system
- It manually initiates a fire alarm when pulled by a person (Correct answer)
- It tests the sensitivity of smoke detectors
- It resets the alarm control panel after an event
Correct answer: It manually initiates a fire alarm when pulled by a person
Manual pull stations allow occupants or staff to manually trigger the fire alarm system when they discover a fire.
Question 6: What is a 'riser' in the context of a fire protection system?
- A device that increases water pressure
- A vertical pipe that supplies water to multiple floors of a building (Correct answer)
- A type of sprinkler head for high-ceiling areas
- A valve used to isolate a fire zone
Correct answer: A vertical pipe that supplies water to multiple floors of a building
A riser is a vertical pipe in a sprinkler or standpipe system that carries water supply upward through the building to serve multiple floors.
Question 7: When a fire alarm is activated in a building, what is the Fireguard's primary responsibility?
- Silence the alarm immediately to prevent panic
- Investigate the source, ensure evacuation if needed, and notify FDNY (Correct answer)
- Wait for the fire department to arrive before taking action
- Reset the alarm panel within 5 minutes
Correct answer: Investigate the source, ensure evacuation if needed, and notify FDNY
Fireguards must investigate the alarm source, coordinate evacuation if a real fire exists, and immediately notify FDNY as required by NYC Fire Code.
F-02 Fireguard Fire Protection Systems 3
Under NYC Fire Code, how often must a Fireguard with an F-02 certificate of fitness inspect the fire protection systems in their building?