F-01 F-01 - F-01 Fireguard Hot Work Operations and Permits Questions and Answers 1

Question 1

What is 'hot work' as defined for F-01 Fireguard purposes?

Accepted Answer

Operations involving open flames or heat that could ignite combustible materials

Answer

Hot work includes operations such as welding, cutting, brazing, and grinding that produce open flames or sparks capable of igniting nearby combustibles.

Question 2

Before hot work begins on a job site, the fireguard must verify that a valid ________ has been issued.

Accepted Answer

Hot work permit

Answer

A hot work permit must be obtained and posted before any welding, cutting, or burning operations commence on a job site.

Question 3

How far should combustible materials be cleared from a hot work area before operations begin?

Accepted Answer

At least 35 feet

Answer

FDNY and NFPA guidelines require combustibles to be removed or protected within a 35-foot radius of hot work operations.

Question 4

After hot work operations have ended, how long must the fireguard continue fire watch in that area?

Accepted Answer

30 minutes

Answer

A fire watch must be maintained for at least 30 minutes after hot work ends because smoldering materials can ignite long after the work stops.

Question 5

Which protective measure is required on floors directly below a hot work area?

Accepted Answer

Placing fire-resistant tarpaulins or shields to catch sparks and slag

Answer

Fire-resistant tarps or shields must be placed below the hot work location to prevent sparks and molten slag from falling to lower floors and igniting materials there.

(F-01) F-01 Fireguard Practice Test

(F-01) F-01 Fireguard Practice Test

F-01 F-01 - F-01 Fireguard Hot Work Operations and Permits Questions and Answers 1