EPA 608 609 - EPA Refrigerant Handling Section 609 MVAC Systems Questions and Answers 3 Flashcards
6 cards from real EPA 608 609 practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 6 EPA 608 609 - EPA Refrigerant Handling Section 609 MVAC Systems Questions and Answers 3 flashcards as text
Which component unique to automotive A/C systems uses a magnetic clutch to engage and disengage the compressor from the engine drive belt?
Answer: Electromagnetic compressor clutch
Automotive A/C compressors use an electromagnetic clutch that allows the compressor to engage when cooling is needed and disengage when it is not, all while the engine belt continues spinning. This is unique to MVAC systems; stationary HVAC compressors typically run continuously or cycle on and off based on system pressure, not a clutch mechanism.
What is the purpose of the receiver-drier in an automotive A/C system?
Answer: To store liquid refrigerant and remove moisture from the system
The receiver-drier stores a reserve of liquid refrigerant and contains a desiccant material that absorbs moisture from the refrigerant. Moisture in a refrigerant system can cause ice formation at the expansion device, acid formation, and corrosion. The receiver-drier should be replaced whenever the system is opened for service to maintain desiccant effectiveness.
When adding refrigerant to an MVAC system, technicians typically charge through which service port?
Answer: Low-pressure side service port (low-side)
Refrigerant is added to automotive A/C systems through the low-pressure (suction) side service port with the engine running and A/C operating. Charging through the high-pressure side when the compressor is running is dangerous because it could cause the refrigerant cylinder to become pressurized. The low-side is the safe, standard method for adding refrigerant charge.
What is the function of the accumulator found in some MVAC systems instead of a receiver-drier?
Answer: It stores excess refrigerant on the low-pressure side and protects the compressor from liquid slugging
The accumulator is located on the low-pressure (suction) side between the evaporator and compressor. It stores any liquid refrigerant that might not have fully evaporated in the evaporator, preventing liquid from entering the compressor (which could cause catastrophic damage known as liquid slugging). Systems using accumulators typically use an orifice tube instead of a TXV for refrigerant metering.
R-12 (CFC-12) MVAC systems cannot simply be retrofitted with R-134a without which modification?
Answer: Converting to a compatible PAG oil and replacing o-rings and seals
R-12 systems use mineral oil or alkylbenzene oil, which is not compatible with R-134a. R-134a requires polyalkylene glycol (PAG) oil. When retrofitting an R-12 system, the mineral oil must be thoroughly flushed out and replaced with PAG oil. Additionally, the o-rings and seals in R-12 systems are often not compatible with R-134a and must be replaced to prevent leaks.
Under Section 609, small cans of refrigerant (2 pounds or less) for MVAC top-off use sold at retail stores may be purchased by:
Answer: The general public without certification requirements
EPA Section 609 regulations allow small containers of 2 pounds or less of MVAC refrigerant to be sold to the general public without requiring certification. These small "top-off" cans are available at auto parts stores for consumer use. The certification requirement applies to technicians purchasing refrigerant in larger quantities for professional service work.