EMP Health & Safety Protocols 2

Question 1

Under OSHA's Lockout/Tagout (LOTO) standard, which step must be performed FIRST before applying lockout devices to energy-isolating equipment?

Accepted Answer

Identify all energy sources

Answer

OSHA 1910.147 requires identifying all hazardous energy sources before any isolation or lockout devices are applied.

Question 2

Which NFPA standard specifically governs electrical safety in the workplace and defines Arc Flash boundaries?

Accepted Answer

NFPA 70E

Answer

NFPA 70E, Standard for Electrical Safety in the Workplace, establishes arc flash boundaries and PPE requirements.

Question 3

An energy manager discovers that a boiler room lacks a clearly marked emergency shutoff. This is primarily a violation of which safety principle?

Accepted Answer

Emergency action planning

Answer

OSHA's Emergency Action Plan requirements (29 CFR 1910.38) mandate clearly identified emergency shutoffs for energy systems.

Question 4

What is the primary purpose of a Job Hazard Analysis (JHA) in energy management operations?

Accepted Answer

Identify and mitigate task-specific hazards before work begins

Answer

A JHA systematically identifies hazards associated with each step of a task so controls can be implemented before the work starts.

Question 5

Which PPE category is required when working within the Arc Flash Boundary but outside the Restricted Approach Boundary?

Accepted Answer

Category 1 (4 cal/cm²)

Answer

Category 1 PPE with minimum 4 cal/cm² arc rating is required for work within the Arc Flash Boundary at lower incident energy levels.

(EMP) Energy Management Professional Practice Test