EIFS Safety Standards & Compliance in Construction 2

Question 1

Under OSHA 29 CFR 1926, what minimum distance must workers maintain from energized overhead power lines when using scaffolding during EIFS installation?

Accepted Answer

10 feet

Answer

OSHA requires a minimum 10-foot clearance from energized power lines up to 50kV when workers are on scaffolding.

Question 2

Which ASTM standard governs the performance requirements for polymer-based finish coats used in EIFS assemblies?

Accepted Answer

ASTM E2568

Answer

ASTM E2568 specifies performance requirements for the exterior finish coat in PB EIFS systems.

Question 3

What is the primary purpose of a fire-resistive EIFS assembly tested under ASTM E119?

Accepted Answer

Hourly fire endurance rating

Answer

ASTM E119 tests fire endurance of building assemblies and assigns hourly fire resistance ratings.

Question 4

Which regulation requires contractors installing EIFS on buildings with federal funding to comply with lead paint disturbance rules when the substrate was built before 1978?

Accepted Answer

EPA RRP Rule 40 CFR 745

Answer

The EPA's Renovation, Repair and Painting (RRP) Rule under 40 CFR 745 governs lead paint disturbance during renovation work.

Question 5

When inspecting an EIFS installation on a high-rise building, which OSHA standard most directly governs the safety of workers using rope descent systems?

Accepted Answer

29 CFR 1926.502

Answer

OSHA 29 CFR 1926.502 covers fall protection systems including personal fall arrest systems and rope descent systems.

(EIFS) Certified Exterior Insulation and Finish Systems Inspector Practice Test

(EIFS) Certified Exterior Insulation and Finish Systems Inspector Practice Test

EIFS Safety Standards & Compliance in Construction 2