Tool Recognition and Use Flashcards

Which tool is used to test whether an elevator safety circuit is open or closed during troubleshooting?

Answer: Continuity tester or multimeter in continuity mode

A continuity tester or multimeter in continuity/beep mode confirms whether a safety circuit is electrically complete.

When pressing a new sheave bushing into a housing during elevator maintenance, which tool is used?

Answer: Hydraulic press

A hydraulic press applies even, controlled force to seat a bushing squarely in a housing without damage.

Which tool is used to check that an elevator pit ladder rung is perpendicular to its side rails?

Answer: Try square (carpenter's square)

A try square verifies a 90-degree angle between two surfaces, such as a rung and side rail.

A mechanic needs to safely lift and position a heavy machine room drive unit for installation. Which rigging tool is used?

Answer: Chain hoist (chain block)

A chain hoist suspends from an overhead beam and lifts heavy loads vertically with mechanical advantage.

To determine the exact voltage at the elevator controller's main disconnect under load, which tool and connection method is required?

Answer: Voltmeter probed in parallel across the terminals

A voltmeter must always be connected in parallel across two points to measure the potential difference (voltage).

Which tool is used to smooth burrs left on a steel guide rail after cutting?

Answer: Mill file

A mill file removes sharp burrs and smooths the cut face of a steel guide rail to prevent cable or shoe damage.

An elevator technician is splicing two sections of traveling cable. Which tool crimps the strain relief connector?

Answer: Ratcheting crimping tool rated for the connector size

A ratcheting crimping tool sized to the connector ensures a full, reliable crimp before the ratchet releases.