EETC - Equipment & Engine Training Council Driveline and Hydraulic Systems Questions and Answers

Question 1

A technician is troubleshooting a zero-turn mower with a hydrostatic transaxle that is noisy and has a lack of power after a short period of operation. The fluid level is correct. Which of the following is the MOST likely first step in the diagnostic process?

Accepted Answer

Purge the air from the hydrostatic system.

Answer

Noisy operation and a lack of power in a hydrostatic system, especially after a fluid change or service, are classic symptoms of air in the hydraulic fluid (aeration). Purging the system is a non-invasive first step to remove any trapped air, which is critical for proper operation as air compresses and causes inefficient power transfer and noise.

Question 2

In a hydraulic system, what is the primary function of a relief valve?

Accepted Answer

To limit the maximum pressure within the system.

Answer

A hydraulic relief valve is a critical safety component designed to protect the system from over-pressurization. When the system pressure exceeds a preset limit, the relief valve opens, diverting excess fluid back to the reservoir, thereby preventing damage to pumps, hoses, and other components.

Question 3

A powershift transmission in a piece of utility equipment is exhibiting delayed, rough shifting and a noticeable shudder upon acceleration. Which of the following is the MOST likely cause of these symptoms?

Accepted Answer

A failing clutch pack or contaminated clutch surfaces.

Answer

Shuddering, jerking, and rough or delayed shifting are common symptoms of problems within the clutch packs of a powershift transmission. These issues can be caused by excessive wear on the clutch discs or contamination from leaking seals, which prevents the clutches from engaging smoothly.

Question 4

Which type of hydraulic pump is generally more tolerant of contamination, has a simpler design, and is typically lower in cost, but is only available as a fixed displacement unit?

Accepted Answer

Gear pump

Answer

Gear pumps are known for their ruggedness, simple design with few moving parts, and lower cost compared to piston pumps. While piston pumps offer variable displacement and higher pressure capabilities, gear pumps are fixed displacement and are more tolerant of fluid contamination.

Question 5

A technician hears a high-pitched whining or a sound like marbles rattling inside a hydraulic pump. The suction line filter is found to be severely clogged. This noise is most likely caused by:

Accepted Answer

Cavitation

Answer

Cavitation is the formation and rapid collapse of vapor bubbles in a liquid when the pressure drops below the fluid's vapor pressure. A clogged suction filter restricts flow to the pump, causing a significant pressure drop at the inlet, which leads to cavitation. The noise is created by the shockwaves from the imploding bubbles.

EETC - Equipment & Engine Training Council Practice Test

EETC - Equipment & Engine Training Council Practice Test

EETC - Equipment & Engine Training Council Driveline and Hydraulic Systems Questions and Answers