ECS - Electrotechnical Certification Scheme Testing and Inspection Procedures Questions and Answers

Question 1

An electrician has correctly isolated a circuit, locked it off with a padlock and warning notice, and proved the circuit is dead using an approved voltage indicator. According to the recommended safe isolation procedure, what is the final essential step before commencing work?

Accepted Answer

Re-check the voltage indicator against a known live source or proving unit.

Answer

The approved safe isolation procedure requires the voltage indicator to be tested on a known source or proving unit immediately before and immediately after testing the circuit. This confirms the instrument has not failed during the process of proving dead, ensuring a false 'dead' reading wasn't given.

Question 2

During a periodic inspection (EICR) of an existing domestic installation, an inspector discovers that the main protective bonding conductor to the incoming gas service is missing entirely. How should this observation be coded?

Accepted Answer

C2 - Potentially Dangerous

Answer

The absence of main protective bonding is classified as a C2 'Potentially Dangerous' fault. While it does not present an immediate danger (like exposed live parts, which would be C1), it is a serious defect that could lead to a dangerous situation under fault conditions and requires urgent remedial action.

Question 3

When carrying out the initial verification of a newly installed ring final circuit, which of the following 'dead' tests must be performed first according to the sequence in BS 7671?

Accepted Answer

Continuity of protective conductors

Answer

BS 7671 and IET Guidance Note 3 specify a sequence for testing to ensure safety. The very first test must be the continuity of all protective conductors, including main and supplementary bonding. This confirms that the primary safety system (the path to earth) is intact before any further tests are conducted.

Question 4

According to BS 7671, what is the minimum acceptable insulation resistance value for a standard 230V final circuit when tested using a 500V DC test voltage?

Accepted Answer

1.0 MΩ

Answer

Table 64 of BS 7671 specifies the test voltages and minimum insulation resistance values. For low voltage circuits with a nominal voltage up to and including 500V (which covers domestic 230V systems), the test voltage is 500V DC and the minimum required insulation resistance is 1.0 MΩ.

Question 5

Which of the following is a key safety requirement for test leads used for voltage measurement on low voltage systems, as detailed in the HSE's Guidance Note GS38?

Accepted Answer

Probes must have fused leads or internal fuses.

Answer

HSE Guidance Note GS38 requires test probes to have fuses to protect the user against high currents in the event of a short circuit. Other requirements include minimal exposed metal tips (typically <4mm), finger guards, and shrouded plugs to prevent accidental contact.

ECS - Electrotechnical Certification Scheme Practice Test

ECS - Electrotechnical Certification Scheme Practice Test

ECS - Electrotechnical Certification Scheme Testing and Inspection Procedures Questions and Answers