Practice Test Geeks(E2) E2 Commercial Electrical Inspector Practice Test
← All E2 Flashcard Decks

Special Occupancies Flashcards

7 cards from real E2 practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Special Occupancies flashcards as text

  1. In a Class I, Division 1 location, which wiring method is specifically permitted by the NEC?

    Answer: Threaded rigid metal conduit (RMC) with listed fittings

    NEC Article 501 requires threaded RMC or threaded steel intermediate metal conduit with listed fittings in Class I, Division 1 locations.

  2. Which of the following best describes a Class II, Division 1 location under NEC Article 502?

    Answer: An area where combustible dust is in suspension in the air under normal operating conditions

    Class II, Division 1 locations have combustible dust in suspension in the air continuously or intermittently under normal operating conditions.

  3. Under NEC Article 504, an intrinsically safe system is one in which any spark or thermal effect is incapable of causing ignition under which condition?

    Answer: Both normal and abnormal conditions as specified

    Article 504 defines intrinsically safe systems as those where no spark or thermal effect can cause ignition under both normal and specified abnormal conditions.

  4. In a Class I, Zone 0 location per NEC Article 505, flammable concentrations of gases are present:

    Answer: Continuously or for long periods under normal conditions

    Zone 0 is the most hazardous classification under the Zone system, where flammable concentrations are present continuously or for long periods.

  5. When sealing fittings are required in a Class I conduit system at a boundary, where must the seal be installed?

    Answer: Within 18 inches of the enclosure

    NEC 501.15 requires seals in Class I, Division 1 locations to be within 18 inches of the enclosure.

  6. Equipment installed in a Class I hazardous location must be marked to show which information as required by NEC 500.8?

    Answer: Class, Division or Zone, Group, and temperature class (T-code)

    NEC 500.8 requires equipment markings to include the Class, Division or Zone, Group, and temperature class to ensure compatibility with the specific hazard.

  7. Class III locations under NEC Article 503 involve which type of hazard?

    Answer: Ignitable fibers or flyings not likely to be in suspension

    Class III locations are those that are hazardous because of the presence of easily ignitable fibers or flyings but are not likely to be in suspension in air.