CWT Safety Procedures & Compliance 2

Question 1

When inspecting a floor scale pit, which confined space entry requirement typically applies?

Accepted Answer

Atmospheric testing for oxygen and hazardous gases before entry

Answer

Confined space entry regulations require atmospheric testing for oxygen deficiency and hazardous gases before any worker enters a pit or enclosed area.

Question 2

What is the correct action if a technician discovers a scale has been knowingly used to defraud buyers by a client?

Accepted Answer

Refuse to certify the scale and report the suspected fraud to weights and measures authorities

Answer

A CWT must refuse to certify equipment used for fraudulent purposes and is obligated to report suspected fraud to the appropriate regulatory authority.

Question 3

Which PPE is most critical when working around energized electrical components of a weighing system?

Accepted Answer

Insulated gloves rated for the voltage level present

Answer

Insulated gloves rated for the appropriate voltage are essential to protect against electric shock when working near energized components.

Question 4

A truck scale approach ramp has a crack extending across its full width. The appropriate response is to:

Accepted Answer

Take the scale out of service until the structural defect is repaired

Answer

A full-width crack in a structural approach ramp is a safety hazard that requires the scale to be taken out of service until properly repaired.

Question 5

Under NIST Handbook 44, which action must a W&M inspector take if a device is found to violate a 'Type Evaluation' requirement?

Accepted Answer

Condemn and seal the device against use

Answer

Devices that fail type evaluation requirements must be condemned and sealed to prevent their continued use in commerce.

(CWT) Certified Weighing Technician Practice Test

(CWT) Certified Weighing Technician Practice Test

CWT Safety Procedures & Compliance 2