CWLP Safety Procedures 2 — Questions and Answers
Question 1: What is the primary purpose of a Safety Data Sheet (SDS) in a warehouse environment?
- To document employee injuries
- To provide hazard and safe handling information for chemicals (Correct answer)
- To list equipment maintenance schedules
- To record daily forklift inspection results
Correct answer: To provide hazard and safe handling information for chemicals
SDS documents provide critical information about chemical hazards, safe handling, storage requirements, and emergency response procedures.
Question 2: When a warehouse worker discovers a chemical spill, what should be the FIRST action taken?
- Begin cleanup immediately using available rags
- Notify the supervisor and evacuate the area if needed (Correct answer)
- Check the SDS after cleaning up
- Continue working and report it at the end of the shift
Correct answer: Notify the supervisor and evacuate the area if needed
The first priority is to notify the supervisor and evacuate if necessary, then consult the SDS before any cleanup begins.
Question 3: Which OSHA standard specifically governs powered industrial trucks (forklifts) in the workplace?
- 29 CFR 1910.147
- 29 CFR 1910.178 (Correct answer)
- 29 CFR 1910.132
- 29 CFR 1910.303
Correct answer: 29 CFR 1910.178
OSHA 29 CFR 1910.178 covers powered industrial trucks, including forklifts, pallet jacks, and other industrial vehicles.
Question 4: What does the term 'lockout/tagout' (LOTO) procedure protect workers from?
- Unauthorized access to secured inventory
- Unexpected energization or startup of machinery during maintenance (Correct answer)
- Theft of warehouse equipment
- Slips and falls near loading docks
Correct answer: Unexpected energization or startup of machinery during maintenance
LOTO procedures isolate energy sources to prevent machinery from unexpectedly energizing or moving during maintenance or servicing.
Question 5: A warehouse aisle is marked with yellow floor tape. What does this typically indicate?
- A restricted area for authorized personnel only
- A pedestrian walkway or traffic lane boundary (Correct answer)
- A hazardous materials storage zone
- An emergency evacuation route
Correct answer: A pedestrian walkway or traffic lane boundary
Yellow floor markings typically designate traffic lanes, pedestrian walkways, or boundaries between work and travel areas.
Question 6: What is the maximum safe load capacity rule when a forklift nameplate specifies 5,000 lbs?
- Loads up to 6,000 lbs are acceptable with supervisor approval
- The forklift must never carry more than 5,000 lbs under any circumstance (Correct answer)
- 10% overload is permitted for urgent shipments
- The limit applies only on inclines, not on flat surfaces
Correct answer: The forklift must never carry more than 5,000 lbs under any circumstance
The rated capacity on the nameplate is the absolute maximum — exceeding it risks tip-overs and structural failure.
Question 7: Which type of fire extinguisher is appropriate for a Class B fire involving flammable liquids in a warehouse?
- Class A water extinguisher
- CO2 or dry chemical extinguisher rated for Class B (Correct answer)
- Wet chemical extinguisher
- Water mist extinguisher only
Correct answer: CO2 or dry chemical extinguisher rated for Class B
Class B fires involve flammable liquids and gases, and require CO2 or dry chemical extinguishers — never water, which can spread the fire.
CWLP Safety Procedures 2
What is the primary purpose of a Safety Data Sheet (SDS) in a warehouse environment?