Practice Test GeeksCTSP - Certified Treecare Safety Professional Practice Test
← All CTSP Flashcard Decks

Regulatory Compliance (OSHA/Z133) Flashcards

7 cards from real CTSP practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Regulatory Compliance (OSHA/Z133) flashcards as text

  1. Under ANSI Z133, a 'qualified arborist' is distinguished from a 'competent person' primarily because the qualified arborist:

    Answer: Possesses recognized credentials and broader technical knowledge of arboriculture

    A qualified arborist holds recognized credentials (e.g., ISA Certified Arborist) demonstrating specialized knowledge, beyond the practical competency of a competent person.

  2. OSHA 29 CFR 1926.502 requires fall protection systems when workers are exposed to fall hazards at or above what height in construction?

    Answer: 6 feet

    OSHA's construction standard requires fall protection for workers at or above 6 feet, though tree climbing uses a different framework under Z133.

  3. According to ANSI Z133, what is required before a climber ascends a tree that has a visible cavity or decay?

    Answer: A hazard assessment must be performed to determine if the tree can safely support the climber

    ANSI Z133 requires a hazard assessment of structurally compromised trees before climbing to determine if safe anchor points exist.

  4. An OSHA compliance officer arrives at a tree care job site for an inspection. Under the OSH Act, employees have the right to:

    Answer: Accompany the compliance officer during the workplace inspection

    Under the OSH Act, employees have the right to participate in OSHA inspections, including accompanying the compliance officer during the walkaround.

  5. ANSI Z133 specifies that a saddle (harness) used for tree climbing must be inspected:

    Answer: Before each use by the user

    ANSI Z133 requires climbers to inspect their saddle and all climbing equipment before each use to identify wear, damage, or defects.

  6. Which OSHA standard applies when tree care workers encounter an energized power line that the utility has NOT de-energized or guarded?

    Answer: 29 CFR 1910.269 (Electric Power Generation, Transmission, and Distribution)

    OSHA 29 CFR 1910.269 establishes minimum approach distances and work practices for employees working near energized overhead lines.

  7. Under ANSI Z133, when using a bucket truck for aerial tree work, workers must wear what at all times while in the bucket?

    Answer: A full-body harness connected to an anchor point in the bucket

    ANSI Z133 requires workers in aerial lifts to wear a full-body harness attached to the manufacturer-specified anchor point to prevent ejection.