CTQP Drilled Shaft Inspection

Question 1

During drilled shaft excavation using the wet method, what is the PRIMARY purpose of maintaining drilling slurry in the borehole?

Accepted Answer

To provide hydrostatic pressure that prevents the borehole walls from caving in

Answer

Drilling slurry (bentonite or polymer) exerts hydrostatic pressure against the borehole walls equal to or greater than the surrounding groundwater and soil pressure, preventing wall collapse in cohesionless or water-bearing soils. The other functions are secondary or incidental.

Question 2

When placing concrete in a drilled shaft using the tremie method, what is the minimum required embedment depth of the tremie pipe into the fresh concrete during placement?

Accepted Answer

5 feet

Answer

FDOT requires the tremie pipe to remain embedded at least 5 feet into the rising concrete mass. This ensures concrete is deposited from below the existing surface, preventing slurry from being trapped inside the shaft. Lifting the pipe above the concrete allows contaminated slurry to flow back into the placement.

Question 3

Cross-Hole Sonic Logging (CSL) is performed on completed drilled shafts to primarily:

Accepted Answer

Detect anomalies, voids, or defects within the concrete shaft

Answer

CSL uses paired access tubes cast into the shaft. Ultrasonic pulses travel between transmitter and receiver tubes; delays or signal losses indicate zones of poor concrete, voids, or contamination. It is an integrity test, not a strength or capacity test.

Question 4

When inspecting a drilled shaft rebar cage before lowering it into the excavation, which item is MOST critical to verify?

Accepted Answer

The number, type, and spacing of concrete cover centralizers

Answer

Centralizers maintain minimum concrete cover around the entire rebar cage as it is lowered and as concrete is placed. Insufficient or missing centralizers allow the cage to shift, reducing cover and potentially creating structural defects. Cover is a primary durability and structural requirement for drilled shafts.

Question 5

The inspector observes loose cuttings and disturbed soil at the bottom of a completed drilled shaft excavation. What should happen BEFORE the rebar cage and concrete are placed?

Accepted Answer

The shaft bottom must be cleaned to remove all loose cuttings and debris

Answer

Loose material, cuttings, and debris at the shaft bottom significantly reduce end-bearing capacity and can cause voids in the lower portion of the shaft. FDOT specifications require the shaft bottom to be clean before any reinforcement or concrete is placed.

CTQP - Construction Training & Qualification Program Practice Test

CTQP - Construction Training & Qualification Program Practice Test

CTQP Drilled Shaft Inspection