CPT Safety 2

Question 1

Which type of fire extinguisher is appropriate for electrical equipment fires in a production facility?

Accepted Answer

Class C

Answer

Class C extinguishers are designed for energized electrical equipment fires because they use non-conductive agents.

Question 2

What is the correct action when a machine guard is found to be damaged or missing during a pre-shift inspection?

Accepted Answer

Tag the machine out and report it before operating

Answer

A machine without proper guarding must be taken out of service and reported immediately to prevent injury.

Question 3

A lockout/tagout procedure requires that after energy is isolated, what must the technician do before working on the equipment?

Accepted Answer

Attempt to restart the machine to confirm it is de-energized

Answer

After applying locks and tags, the technician must attempt to start the machine to verify all energy sources have been properly isolated.

Question 4

In a manufacturing facility, what is the primary purpose of a safety data sheet (SDS)?

Accepted Answer

To provide hazard and safe handling information for chemicals

Answer

An SDS provides detailed information about chemical hazards, safe handling, storage, and emergency response procedures.

Question 5

Which condition would most likely create a slip hazard in a production area?

Accepted Answer

Hydraulic fluid spilled on the floor

Answer

Hydraulic fluid creates a slippery surface that significantly increases the risk of falls, which are a leading cause of workplace injuries.

(CPT) Certified Production Technician Practice Test